I have an issue tonight with my lt40SH. I went to change blade, i loosen the tenison to 0. Tool old blade off and the wheel wouldnt slide over so the new blade would go on correct. Usually i just put the idle side wheel over and put new blade on. I hit it w rubber mallet and block of wood. Its locked up. Wont budge. I made sure the tension handle was out about 2 inches thread showing. Still locked as if the tension hadnt been released. What you think?
@Lee-qp6gf3 жыл бұрын
Good trouble shooting. Good to see you again. God bless you too, Lee
@jdelbrid3 жыл бұрын
Great video. Good troubleshooting and repair. 👍
@isaiahwalker57533 жыл бұрын
I’m glad to see you doing well, and the sawmill running fine
@timothychristian91403 жыл бұрын
It’s been a while since I seen a video from you. Of course I was out of commission for a little over 3 weeks with COVID PNEUMONIA. Love watching your videos.
@jdelbrid3 жыл бұрын
Hope that you will get a full recovery.
@timothychristian91403 жыл бұрын
@@jdelbrid thanks. It’s a slow process but trusting in the good lord for complete recovery.
@iamruseriousnow5163 жыл бұрын
So happy to see a video from you. I wait for one every day. Hows the new shed workin for you? God bless you and your family.
@southernindianasawmill13673 жыл бұрын
Sawmill shed is great! We've been a bit busy lately, so not a lot of time to record and edit anything.