X-ray Image Laser Scanner Reverse Engineering. Philips / Fujifilm PCR Eleva S (Part 2 of 3)

[@KaizerPowerElectronicsDk]

Part 3 of 3: kzbin.info/www/bejne/n2O3mnqcicp9eNE

[@electroelectronics4513]

Thanks very helpful video🙏

[@amitkumarsingh5783]

thanks for video.

[@electroelectronics4513]

Make a video fuji t2 display board

[@T2D.SteveArcs]

I think you can just ground the start stop pin iirc , i played with one from a laser printer a long time ago

[@KaizerPowerElectronicsDk]

I am positive, that I did try to ground it. On the other hand, I could be completely mistaken.

[@T2D.SteveArcs]

@@KaizerPowerElectronicsDk I may be miss remembering aswel mate.. cool video anyway, its good to show people this stuff...👍👍👍

[@june9713]

Thanks for your greate video. I have one question, Any way to know ho to read output of laser by sensor? Now I cleary understand how to make laser line,but I still dont undetstand how to read it at last. Thank you so much your greate greate video.

[@KaizerPowerElectronicsDk]

From how the x-ray image is converted from a "single pixel exposure" into a gray scale image, I would guess its something like a 0-255 value per pixel, to determine the gray scale.

[@en2oh]

Is there a part /

[@en2oh]

Part 3? 😉

[@KaizerPowerElectronicsDk]

yes! Part 3 was just named a bit different :o kzbin.info/www/bejne/n2O3mnqcicp9eNE

[@roentgen226]

Jeg fik en lübcke 10A 3 phase Motorstyret variac der ligner din rigtig meget inden i

[@KaizerPowerElectronicsDk]

Jeg måtte sælge min 25A motorstyrede 3 fasede. Den tog alt for meget plads :)