XK K110 helicopter with Spektrum DX8 using iRangeX

How to set up the XK K110 helicopter to work with Spektrum transmitters using the iRangeX multiprotocol module.
Bootloader information: • iRangeX IRX4 Plus Mult...
flash-multi: github.com/ben...
Multi-module firmware: downloads.mult...
Multiprotocol code: github.com/pas...
Arduino IDE board definitions: github.com/pas...
Arduino compiler: www.arduino.cc/
Instructions for flashing firmware: github.com/pas...

[@eksine]

Dude years ago when I watched your videos I was amazed at how knowledgeable you were with the zx6r. I used to have that bike. I did some technical videos too but I found out later no matter how much knowledge you give out, the main thing people want is to be entertained, so my channel never caught on

[@temptationsoul]

been looking for this . thanks a lot.

[@tjratz1]

Thank you for this video! Will this work the same for the new k110s?

[@kalkurap]

I have a JR radio that takes external modules. I am hoping that if I use the iRangeX Plus module in the external bay, your method of setting it up would still work. If you have any thoughts on this, please comment. Thanks for the video, really helpful.

[@ontariodoublex2713]

Wish there was wn easier way to do this

[@zmanphx]

Get a multi-protocol / module/ radio with Open TX . I fly spektrum, Futaba, Frsky all with one radio. There is no reason to be boxed into one protocol ecosystem.

[@zmanphx]

Daisy chain tx to rx to tx to rx

[@fpvtechnology837]

Too much complicated!