XTOOL RA2 PRO V2 Rotary Switch Installation (Hidden Mount)

[@brianpacchetti5028]

XTOOL RA2 PRO V2 Rotary Switch is a great idea. If RA2 is constantly used, your switch will enviably save PCB connector from pulling away from solder pads. I JB Welded my connecter to PCB but don't trust it. Good engineering and thoughtfully implemented.

[@EmbraceMaking]

Thanks! Yes this is one of the reasons this was made!

[@annamaldivad]

Great video. Thanks.

[@EmbraceMaking]

Glad you liked it!

[@ArturoGarciavillagomez]

Haces envios a México ?

[@ArturoGarciavillagomez]

Do you send to México ?

[@jeranking]

Will this work with the xtool d1 non pro?

[@EmbraceMaking]

Should work just fine :)

[@jeranking]

@@EmbraceMaking thank you! Where can I order!

[@EmbraceMaking]

@@jeranking embracemaking.com/products/xtool-ra2-y-axis-switch right here, thanks!

[@mpcaz]

Well I knew it was only a matter of time before someone else copied my solution for switching from Y to Rotary. Looks nice. Mine does allow using 2 rotaries so you can keep one in Chuck mode. I've sold over 520 switches so far and I should have patented it but didn't have the $$ so good luck with your sales.

[@EmbraceMaking]

Hi , thanks for the comment and congratulations on your sales. For the record I've never seen your switch before, rest assured I never copied you. This seems to be a generic idea that's been floating around these laser machines for a while now. Best of continued luck with your sales and products as well!

[@daleflynn8668]

How can we order your switch

[@Qwiv]

Since I don’t keep the rotary in the bed as I need the entire bed, and my laser is enclosed, an extension cable solves all problems. Will take years to wear out the extension.

[@EmbraceMaking]

Lots of different ways to approach it. A lot of people also just like the convenience of flipping a switch :)

[@Qwiv]

@@EmbraceMaking hobbies I guess.