Yamaha 115 tilt and trim refill

[@foff-666]

@ 1:08 that is such a danergous thing to do - you can EASILY lose a finger. hydraulics let go when they hit air bubbles. nice.

[@romer431]

Thank you. Thomas Denmark 🇩🇰🇺🇸

[@JA-gx4hb]

Thanks for posting. Now do a video on changing those leaky seals.

[@SWFLFISH]

I did , kzbin.info/www/bejne/e4rMdnafpsh4fMk

[@SWFLFISH]

Thanks for watching 🤙

[@coreywallace1362]

Dumb question same motor once it hits the trim rods is it normal to be that slow going to trim down to transom feel like mine is super slow

[@SWFLFISH]

Hey Corey , yea mine is slow too, it’s supposed to be slow , then the big one goes faster

[@NunyaBizz_22]

Yea , - as you already know.. but the REASONING for this is when you are that low in trim, the corrections are smaller due to the speeds you may be at for low trim( on plane perhaps) so your trim inputs don’t “over correct” per se

[@NunyaBizz_22]

To folks looking this up- you can use normal automatic transmission fluid for this if needed.. check your fluids about once a week if you’re an avid boater 🤙🏼

[@guebsiali8875]

What caused the fuel pump to fail? Because in the span of 6 months, he changed three times, and I don't know why

[@SWFLFISH]

Internal float was not sending the signal, just got old I guess

[@Cotton603]

When i trim down a ton of foamy fluid comes out the top of the cylinder is that normal

[@SWFLFISH]

No it’s not , your seal is broken and leaking

[@chriscollins4539]

Thank you for the video? My question is why would it be low? Did you have a leaking seal?

[@SWFLFISH]

Yes I did , leaking right by the cylinder and the top of the reservoir too.

[@cameronpaulk4449]

How do you know when to stop filling?

[@SWFLFISH]

It will pour out

[@bullfighter1801]

What is the plastic adapter fitting that screws on to the quart bottle? Thank you

[@SWFLFISH]

It came with the bottle when I purchased it

[@KeithJohn-qd6pr]

was pretty safety conscious until that point!

[@thomasjohnson9768]

thanks my issue too.

[@cjharrin]

No