ZEISS CMM CALYPSO MILL PART 4 FREEFORM SURFACE

[@dunotrustistrue5565]

I'm transitioning from PCDMIS to Calypso. Your videos are great. Mark

[@Htheng640]

Thanks for this clip

[@marcing223]

Could you please show what yoi do a bit slower for the people who are not that experienced with programming ?

[@rajuprabha9619]

What about that 45deg angle measurement??

[@BrianWickhamMFG]

Part of the profile tolerance.

[@HowDareMe]

It would be best for you to take a ASME Y14.5 class if you can. It will save you a lot of trouble in the future.

[@HowDareMe]

You could have recalled feature points for your plane 4 and 5 since you already had the data from your outer scan. I'm sure you know that, but for all the people learning reading these comments.

[@pratikgadhiya8772]

Hello Professor Wickham, While measuring the profile of a free form surface we take space points, So for a point if the profile shows -0.08 deviation do i consider it against the direction of arrow of the Y or do i consider it -ve against the direction of the arrow of the space point? I am stuck on it and your response will help me a lot

[@rushishinde7650]

Hello I want to know what is CAA Calibration can you tell me

[@mohdnazrin21]

5:05

[@VietNguyen-dz3vy]

Could you help made a video how to apply Cook Book in Calypso software program and explaination details all of symbol measurement dimenstion in Calypso?

[@ginotacobell3098]

Thanks for sharing this video. I see there are 4 planes inside the pocket. Is it a good practice to get a distance of 2 planes in Calypso? Thanks

[@BrianWickhamMFG]

I think it is. But have used lines as needed.

[@ginotacobell3098]

@@BrianWickhamMFG Thanks for your reply. Even 2 planes or lines if they are NOT parallel then the result could be different?

[@kuei1215]

FYI...This feature is an option.