ZR1 Corvette with a Kong 2650 Blower is UNREAL!

We hit the American dream jackpot with this one. Installed a cam and a Kong 2650 blower on the ZR1 Corvette and unleashed some serious power on the dyno!

[@Crushin_Libs]

Excited to see this, I remember seeing it on the lift; impressive Vette!!!

[@michaeldyer6304]

How bout those cam bearings.....

[@Cammedup1225]

We made this power on a bad baro sensor limiting him to 11.8psi of boost. Not to mention on only 13 degrees of timing. Which is crazy conservative. The cam bearings shouldn’t be an issue.

[@Evans_auto]

did you leave that square gasket on when you put the lid back on? That is included in the 2650 blower if you are going to be using it on a CTS-V, not a ZR1. The original two black gaskets have to be used on the ZR1.

[@Cammedup1225]

No sir the black gaskets were the only ones used. We attempted the square gasket but of course the lid didn’t fit for obvious reasons 😅 Thanks for watching!