Someone's getting a new roof installed in the background.

Nice job! I was wondering if the four cement blocks holding the floor would limit the weight you can put on the shed

I lived in Pensacola and went to Pensacola Christian College. Your idea won't work without a slab or a deeper foundation I went through 3 hurricanes, 2 in Pensacola. The worst damage was in Mobil.

Simple, easy and practical. Thank you!

The problem with samsung firmware not update properly, as on video, solution replaced main board that contain firmware and don't use wifi/internet anymore. 😢, buy tv box.

Hi a friend gave me a shopvac..but it makes a shrill noise..or should I grease it so the noise is normal? Thanks for your video

No fliter change?

Great video. Looking to build a 12x12 shed this summer and this is an excellent guide.

Some people are just better than others! 😂

My daughters kluger went in for a service and her brake pads where not installed correctly and it could have been fatal. We had her car serviced rd again at a different garage and they did the same with the rear brakes. We do our own servicing now. Thank you for your video much appreciated

Mine turns on to a blue screen and in 5 seconds turns off then on again continuously until unplugged. Battery less charging remote buttons are not sticking. Disconnected yhe Samsung BT sound bar, eithernet, OTA antenna and all HDMI cables. Replugged straight into wall. No change.

So, the solution is to but new mainboard ... lol ... it's not repair exactly

I need to make my own temporary gate and this one is perfect for me, the opening and the tools I posses! I don't have a table saw but I figure a router would have the same outcome. Cheers mate. Too bad we can't put photos in comments to show you the end result.

Thanks for the information. How has the TV performed since?

I have this same vehicle and need to replace all four struts/coils. Where did you get all the torque specs? Thanks!

I would of do factory hard reset first

Works in sandles! not safe at all!

Very good and insightful video..

Great job.. exatly what i was looking for.. thanks much brother.

Ok now do a video WITH NO attic

Man you guys got it easy my coils got a bunch of pipes and connections in front of it.

I have a similar problem except it shows a screen like how a wave from ocean goes

Hi , when I refuel the highlander 2011 the fuel economy reset itself and shows 30L / 100km and after running car for 80 km it come to normal as 14L/100km or 13l/ 100 km but when the car need refuel this changes again and shows 30L/km again for another 80 km , how to fix this issue , thanks.

No more Walmart nail polish!

❤

Great video! Ryan does a fantastic job walking through the troubleshooting and repair process for the Black Max weed eater. The step-by-step guide on cleaning the carburetor is really helpful, and the tips on fuel types and engine maintenance are a great bonus for preventing future issues.

Just got mine, and this is an awesome mower! This video provides a great guide on replacing the deck belt and blades. The step-by-step instructions and tips on handling common issues like stuck bolts make the process much easier. After the replacement, my mower’s cutting performance has been fantastic!

So when you use the system do you have to turn it on and off? Could I possibly hook it up to a water timer?

Looks great for any mobile home!

Thanks for sharing this. I took my boat out yesterday and it went into limp mode (wouldn't rev past 2500 rpms under load). Got back to the dock find that my reservoir was dangerously low on oil despite having filled it recently. Pretty sure this is the culprit. I've also read that oil can leak out of the rubber fill assembly on the top of the reservoir. Have you experienced that?

Mine just makes a good awful sound and it gets really hot. I have it apart right now. I don't think a fuse is the problem. It turns on, it just screams in agony. I even apologized to it.... 🫤

What if i dont have a torque wrench can i just to it till it really tight?

Your shed is awesome

Great video and great clean job thanks

Opened my shopvac (ArmorAll) and it looks nothing like this one. No idea what's what and everything is covered in drywall dust :(

Liked that peace and God bless at the end, I would suggest you work with a professional plumber to learn proper plumbing techniques and correct plumbing materials to uses you make too many mistakes to mention but with the proper training you could become good at this kind of work. I been in the trade for over 40 years and as a young man trained by lic. Plumbers

Can I replace my timer box with a Leviton 1288 switch as I have solar hot water and I only need to turn the water heater on once a month. The switch looks like it switches powered between two outputs. I’d like to use the switch to also power a 220v outlet (to also be added) to handle like a 24amp or 16amp level 2 car charger.

How do I prevent the metal fuel tank from rusting? I live in a humid environment and it seems like storing with fuel would be better?

What? You think the average person is going to fling open up their tv LOL

I would never use any aftermarket parts as done here. Your original parts lasted almost 200,000mi. Aftermarket parts will last maybe 20-30K if you’re lucky. Always use genuine parts on a job like this. You should not turn the bolts going through the strut clevis, only the nuts. Finally, wheel nut torque is 103Nm (76lb-ft), not 100lb-ft.

Very helpful, thanks.

Good job sir

How do you replace the electrical cord if that is what is wrong with it?

Please advise how you place the right spot for adjusting the sliding distance…

where did u buy the pump from?

I run my big generator every 6 months or 1 time per year. But I did had gas stabilizer the first year. I only have my generator 3 years now. But I plan on running it every 3 months now. My small portable dual fuel generator I run at least every 3 months. Sometime every month, because I take it to work on house. I am getting a power station so I probably will use the small less, so I will have to remember to do maintenance runs on it. I would advise people to run their generators as often as possible because I do see some rust in my big generator tank, but maybe it just sediment from the tank or gas

This is interesting. I'll have to try it.

Can you explain the rationale behind the 15 amp fuse? I'm doing mine now and wanna get it right. Not saying it's wrong, I just don't know the reason why it's right, you never said. Is it the logic that the motor is like 12 amp so 15 is the closest without going under?

How about just run it once per month for 30 days under load .... This way you dont have to prep it for storage PLUS if it sits for years and you need it, what if in the time its been stored and something went wrong ?? You go to use it and it does not work. This is why you just run it on a normal basis to keep it working

Great job. For myself I'd rather go with the pre fab joist and walls done for the extra 500 bucks