@bgarrison67 🤣 yeah this soil is mostly clay but no doubt I got lucky. Usually it takes me a bit more. Like 4 ft and then gotta finish it w/ hammer

@@paynfulmakers8405 I posted a link in the description.It's the ultimate.

yeah not all this should be carried but it can and some times if im doing a service call i load it ALL up and use it as a tool bag it fits and its all together

@@dr.haroldweinstein5157 yeah trades are not for every 1

@@NeanderthalDogma red cedar. Very soft

@@NeanderthalDogma pfft nvm lmao re watched I'm a dumb dumb. Mfd.....

@@NeanderthalDogma thanks

I recently tapped a hole in a fujia stripper I have and it works well despite the diy. The one thing it dosent like is thick insulation like aluminum stove wire.

@@MattHmm-rq6dn yeah, you have to follow the spiral of the nm cable as it turns i did it on 8-3 in a short and live

I'll keep this in mind it was for 50amp stove plug in a 70s apartment aluminum stranded no neutral. It was too thick to cut it in the v. I doubt this wire is something they would use these days since it needs a white neutral on modern stuff. The only point made here is won't work on some thick cable. I wish I saw more 8/3 unfortunately I'm lucky to see grounds on plugs at times 😆. I'm "glass" I'm "fused" to the job for now!

@@MattHmm-rq6dn I got ya

yes, coming up! thx

Thanks 👍

not yet ill drop 1 in future videos soon

dang i saw that but i dont think its gona deliver looks very long and gona brush your thighs? thanks

@toolsandtactics yeah the mini niko looks a little long, but I'm not against modding my bags if the layout/capacity is what I'm after 👍

That's a good setup for a 701 vest. You don't need everything all the time. A alternative for people is the veto dp3 which many got in the spring promo makes a good primary bag for a diamondback vest or even tool belt.

@MattHmm-rq6dn haven't checked out the vest, but do have the DP3. The vest might help to secure that thing, as it is, seems pretty unstable with just the clip

I put my dp3 on a madpac to make it easy to take on or off and drop it a little lower on my waist. But it will work however you do it. I have long arms I'm even hang my mp2x on a tape clip holder(rackateirs) leather to drop it a tab bit lower.

you spelled installed wrong

@@toolsandtactics 😂 I was going to put "elected"

this is clay north texas have you tried it? you can get atleast 4 ft before you need to start hitting it just DONT stop moving it or its stuck the second you stop moving it you're done!

Houston Black Clay primary make up around here

@marksheltonswork7848 no, I broke the law lol No, I did a line locate about eight months ago when I first got the house, so I knew where the gas was, but there's a small chance I could have hit my plumbing, and the electrical was overhead

@@42588panda I don't even know how they can make it any better. That button better be smaller

@@pauls2228 haha

Yea especially texas ground hard as a rock sometimes

@trevorhood6002 haha. Yeah this 1 went amazing I got so lucky! No prep just bs trash talk and dint have to eat any crow. Amazing

@@bluecraney1 Honestly, a ground plate. It's something everybody should be doing.You don't have to dig them very deep, and they're not hard to achieve code

somebody had lied to him about how big a inch is

@@davidquesenberry7366 so dry here in Texas. Hard ground