Preventing rott but he missed a cut

Yeah that's all well and good but the hack left the label on the end of the board! That's just bad form

That looks like treated lumber, so I would say he's wasting his time.

If your concerned about water you should have flipped the board over because of the grain pattern ,when that board drys out it will have a tendency to cup and hold water on top of it.Its actually called a “Crown” so if you flipped it the water would run off of the “Crown “

That would be me.

Better a nail than a clamp, no fighting it, just temp hangar

Glasses at the end made the video! Lol

Absolutely nothing wrong with how it looked before. For a few $1000 could’ve updated the existing landscaping. This is way too over the top and way too much $$$$. Of course this is the builder’s favourite… 👎

🤣👍 A lot of Contractors are leaning to do more by themselves. Waiting for Gen Z to come to work.

Treating it like a pruned tree.

Looks like the helper is sitting home today

I and every framer I know have been doing that for decades ,me 4 1/2 decades

Unt Z helper nail..

I did this on my mailbox post. Let that sucker soak for a week.

I don't understand, they spray a water repellent on the ends of the wood, but then you see a worker beating a wood plank down in the groove defacing the wood surface! 😅😮🙃

We think Tony is the best. Always learn something new from him

Gotta put a continuous bead of silly cone on the overlap or it WILL wick up and leak. pull the bottom wrap off and apply the bead on the ground; drag it up there upside-down to not scratch the bottom. Flip it over in place.

Wanna see somethin CooL

Staining and sealing the whole deck

Maybe place the videorecorder, and do timelaps of all the work

Tip for pulling out those concrete squares: drill and install a drop anchor and screw in an eye bolt in the center. Pull it out

Wood with ground contact? I'm not surprised, you are building houses out of sticks 😂

That was clean

It was still off though

Termite prevention???

He forgot to do his end board pull it up and do it again 😂😂😂😂😂😂

His wife

would love a full length video on the build!

Hey stop marking up my decking

If that on the ground, it needs to be pressure treated

Wrong

I want her to assemble my sauna…!!!

What about the conduit pipe

Used motor oil like old farmers paint??

Its pressure treated, no matter where or how you cut it its already sealed.

You’re off by a 1/6”, no Bien

I enjoy wood clamps, my favorite 🤔

I recognize that view. You were a few blocks away from our new house. As I have posted on your videos before we are almost ready to reach out and hopefully schedule you guys to do our backyard. We're right on the lake. I can't wait.

Без слов, но так доходчево. Красавчик!

I only use my 32" stabila.

Smart enough to cut the piece yet not smart enough for a fine tip marker. Also that piece could have been screwed to last piece laid so no face screw required. Keep practicing you'll get there

Damn silly 😜 got holidays all in it

Why not remove staple and tag

How come ur using 2 3/8” ring? Hey Mr George……

So, is he goona get some buddies to help him lift this on some deck blocks? I dig that kotch bit but im confused on gravel. Whats up?

i’ll site those lines all day long, they’ll look like a noodle. install all your field boards long, cut whole length at once , straight edge and circular saw. then lay ur accent pieces.

precise work with a carpenter’s crayon lol

Beautiful!

More blue collar? How about doing it all with a estwing hammer

You guys can come out of the closet...its 2025.