Thank you🩷💥

What scanner is that?

Very good video, Hector. Thanks.

At 7:15 when you switch your test light to battery positive to check command from computer to the purge, did you also switch the back probe to the orange wire?

Cool but he did to much the primer wasn't necessary and neither was the base coat. All he needed was some clear coat after he was done with his sanding process. I guess there's more than one way to skin the cat. The orange peal comes from not have the proper spray set-up. A harbor frieght gun and compressor would gave you better results. Sand the orange peel is a good technique.... but clear coat normally needs about a month to cure. In the curing process the clear coat shrinks... so if you sand while the clear is still fresh you run the chance of getting cracked clear coat in the future causing it to rise off the base. Good job though.

Dad: Want to go check the jeep? Son: No Little did his father know his son had owned a jeep before...

How much this type of job would normally cost

When you have the alternator replaced, is it standard to replace the diode?

A very good video homie

do you have part numbers for those by any chance

A very clear and a good and informative video. Thank you very much

THAT was the best trouble shooting video I've watched in a long time!!! Well done Sir!!!

Bro where is your shop

The starters buried in there.

Very good job

I’m going to take the bed off. That looked like a pain dropping the tank. Thanks for your professional diagnosis!

Thank you! I have an old Jeep Cherokee and for the 1st time in more than 20 years I can't get it to run because of something in the engine control system. This is going to help me a lot in trouble shooting the relays and their circuits.

2017 vw Passat put new battery in crossed the battery cables started sparking headlights flashing horn beeping.re disconnect positive negative the right way check the fuses inside outside battery keeps draining car turns off have to charge it. Take the charging cables off car dies out.

Are you mobile?

Rotate the chingadera 😅😅😂😂

Goo job but, Please protect your lungs listen to your voice in the video you can hear the effect of the chemicals in the spray. SAFETY FIRST!!!

Bien Héctor bien, gracias hermano.

That was clean bro

Thanks , this is the first video after 1000 searches that is exactly what I was looking for ! Thanks once again <3

RIP The funeral was a sad event but was glad I could attend. Condolences to the family. Gone too soon

You should be wearing a respirator when using that 2k clear.

Awesome tutorial. Love your videos.

Is that connector the same on all hondas? I have an 08 civic lx doing this nois, i would like to unplug the alternator to see if this is it but worried about unplugging something wrong lol

What about the back bowtie? Does it come off the same?

Bro, you need to wear a mask! Especially with K2. That stuff hardens and crystallizes in your bronchioles and alveoli and you lungs stop functioning. No to mention you can get cancer. 😮

Achilles.

First time to your channel, when I saw 16min video length, I almost moved on, glad I didn't, you are very knowledgeable, not only did you help me get closer to my solution, the 16min flew by, you made learning enjoyable, that is a true gift!! Just subbed ✌💚

Dang you’re good

HECTOR ERES UNA RIATA EN FORMA DE CLAVO 😂👍

ALL SIENNAS ??? Are all the Sienna models this complicated to remove the spark plugs?

Marvel mystery oil works good 👍🏿

I can hear my relay clicking but not working

Love when dealers are exposed!

Great points, great job for a at home job....

I’m studying for ASE T2 test right now. Wish me luck

Does the wheel speed sensor affect the speed as you drive? What will be the symptoms?

Gracias

You're an asshole.

Hey hektor how long did this whole process take you?

OEM Nissan wires for those cars, or NGK.

Thanks bro for sharing.

What scanner are you using bro

Which Autel model scanner are you using?

I think this video may be the most helpful one I've seen on the speed sensors. And your presentation skills are excellent. You should be in the sales department for a major manufacturer.

What happens if the lock ring does not grab?