Origin Effects

Пікірлер

@mikehoehn1475 8 күн бұрын

Will this work plugged into a crown power amp split into 2 12in. Speakers??

@OriginEffectsUK 8 күн бұрын

Yep, running this into a clean power-amp and guitar cab is absolutely something you can do.

@vivianaisabelacunasanhueza8848 10 күн бұрын

💋

@mrnorbotron3308 12 күн бұрын

5:37 I don't hear a difference at all.

@metalmick 12 күн бұрын

I want one so bad. Time to sell some stuff on Reverb to fund it!

@fritzhieke7209 14 күн бұрын

Please show the knob controls and not the guitarist

@fritzhieke7209 17 күн бұрын

So the "Dry" signal don't give me the full dry signal of the clean amp but somewhat in between? I don't understand it. At 5:46 shouldn't we here just the clean amp?

@OriginEffectsUK 17 күн бұрын

The DRY control is a dry level control which adjust the amount of DRY signal next to the overdrive, not a blend/mix control.

@fritzhieke7209 17 күн бұрын

@@OriginEffectsUK but isn't that the same? If the amp is clean the dry signal is not the clean amp? What is the dry signal in this case? Sorry about my confusion.

@OriginEffectsUK 17 күн бұрын

@@fritzhieke7209 Some blend controls are a sliding scale from all the way dry, to all the way to the overdrive signal. Which is what you're describing. Where you're panning between two outputs, the dry and overdriven circuit. Some adjust the level of the dry signal next to the overdrive signal. Which is what ours does. The overdrive circuit is always reaching the output of the pedal, the DRY control adds dry signal to the output. You can't take the overdrive circuit out of the output unless you turn the pedal off.

@fritzhieke7209 17 күн бұрын

@@OriginEffectsUK still not understand what the dry signal here means but I have to play more around with it, I hardly hear difference besides the level changing. Nevertheless, the ADAPT feature is brilliant!

@mrnorbotron3308 19 күн бұрын

Is it also suitable for bass guitar (yes I know there is a Cali76BassComp)

@OriginEffectsUK 17 күн бұрын

You can certainly use it on bass, we have a few artists who do!

@user-yr6zj2po1e 20 күн бұрын

Been using my dynacomp forever, but got this today. Seems overly complicated but thanks for this video. I'll figure it out.

@OriginEffectsUK 17 күн бұрын

We'd prefer to say the dynacomp is undercomplicated! We've released some videos more recently that dive into every part of a compressor which may be helpful.

@user-yr6zj2po1e 17 күн бұрын

@@OriginEffectsUK Thanks. I've been experimenting with it these last few days and it's growing on me.

@kellymorse8835 21 күн бұрын

Mark was my nephew. Nine months older than I. He was not much of a slide player himself, but he made it a lot easier for many to improve their playing.

@ThomasHope73 22 күн бұрын

I’m a fan of Origin Effects and own a stacked Cali 76. I like the videos and just want to offer one bit of constructive feedback. Perhaps it would be an improvement to move the script closer to the camera and maybe make it smaller so that John’s eye movement doesn’t seem unnatural. (I find myself being distracted from the content a little when a presenter seems “preoccupied” with their script because they are “looking over the shoulder” of the camera with eyes darting from left to right.) Apart from this, great content as always. Cheers 👍

@OriginEffectsUK 22 күн бұрын

In the process of getting some sort of Teleprompter setup as it annoys me to!

@rx2enemy190 22 күн бұрын

Best demo ever. I love how they combined attack/release into one knob.

@lewtarnopol7444 26 күн бұрын

I'm annoyed this demo uses your Cali Bass Compressor model rather than the FET model that I own. I specifically bought the FET model to enhance live performances of my acoustic Taylor piezo (both with and without IR modeling) and often struggle to nail down the right sound, while the Bass model used here seems more turn-key and easy to achieve the sounds I'm looking for. Your website advertising literature steers the acoustic guitarist towards the FET model and bassists towards the Bass model. As a former recording engineer who often used beloved UREI 1176 compressors on everything from vocals to drums to various instruments, I believe your line of pedal compressors are the highest quality devices on the market today, but after watching this video I think your marketing department needs to rethink nomenclature used to identify and describe your products so customers are more informed as to which model to buy.🙁

@OriginEffectsUK 24 күн бұрын

We actually use the FET last in this video, the point being you can successfully use either on almost any source. It just comes down to the feature set you value/want more, independent Attack and Release, or a HPF in the sidechain. The FET works great on acoustic, as does the Bass. Just depends on the features you're looking for. The pedalboard in this video is my personal one, and I chose bass because my acoustic puts out a crazy amount of low-end. I'd favour the FET if I were always using IRs or had an acoustic which was more neutral.

@lewtarnopol7444 24 күн бұрын

@@OriginEffectsUK John, I appreciate you taking the time to reply. I do enjoy having separate control of both attack and release on my FET unit and, if given the choice again, would still choose FET over the Bass version. Thanks for illuminating some of the differences between the two units. Cheers.

@donwershba2319 26 күн бұрын

Great Demo - Great Playing - Origin Effects are truly superior

@josearjona3728 27 күн бұрын

You are making GREAT videos about your products: Simple, quiet and honest information. Well done.

@dividedbytimestudios 27 күн бұрын

Finally more acoustic stuff, how come yall used the bass compressor and not the standard? Does it do something different than the regular version?

@OriginEffectsUK 27 күн бұрын

For the most part, we found having the ATT/REL combined provided enough control on acoustic, and acoustic pickups and mics spit out a LOT of low-end, which the HPF was useful for. Either can work great. Just depends on what you're doing. The pedalboard setup is my personal board and I run a bass on it.

@fredsaintfelix6828 27 күн бұрын

I’m running a Calli 76 stacked edition currently. Do you have any recommended settings? When I’m building up in the bridge section of a song it’s compressing too much. I would like to just even out my picking and strumming.

@OriginEffectsUK 27 күн бұрын

@@fredsaintfelix6828 You'll likely just want to lower your IN and THRU settings. If you just want to hit peaks. Using the two LEDs, they should only activate in the very loudest parts of your signal.

@vinicmag 27 күн бұрын

i have the v1 compact deluxe and I really loved the boost setting

@fritzhieke7209 Ай бұрын

Terrible presentation. This one is better: kzbin.info/www/bejne/hoHWm5KpmNxjiZY

@mcdonnellkieran68 Ай бұрын

Would this work straight into a powered speaker to use as a stage monitor for myself?

@OriginEffectsUK Ай бұрын

Yep, just take the XLR out of the back and throw it into a powered monitor.

@mcdonnellkieran68 Ай бұрын

@@OriginEffectsUK great thank you. But what about then if i want to use as a D.I. For FOH desk too? Thanks a million

@OriginEffectsUK Ай бұрын

@@mcdonnellkieran68 Send the DI to front of house and ask for the Engineer to send you bass in your wedge. Alternatively you could use a XLR split.

@attak1326 Ай бұрын

@Ian because of you I bought mine

@joerectifier Ай бұрын

This is a video done correctly! No foolish or folksy attempts at being a “personality” or “MC”, just clear, direct and effective explanations of how the pedal works….i am very interested in this pedal and enjoyed this video!

@TechMetalRules Ай бұрын

Jack's great! Mine just arrived from Sweetwater!

@jongonzalez6917 Ай бұрын

How do you think this would sound through a JMP to boost/give it more gain?

@OriginEffectsUK Ай бұрын

I'm sure it can be done, but these are effectively amp pedals rather than normal overdrive/boost pedals. If you're just looking to push your amp, our DCX, M-EQ DRIVER, or Halcyon pedals may be a better choice.

@Cov3nKing Ай бұрын

This video convinced me to buy it 💀💀💀 many thanks Ian 😂💸💸💸💸

@fritzhieke7209 Ай бұрын

You forgot to disable and enable the pedal from time to time so everybody can here what the pedal actually does. pointless noodeling and cringe posing doesn't help much, no offense.

@OriginEffectsUK Ай бұрын

That's why we have other videos of the pedal.

@GuitarUnderground Ай бұрын

Thanks for this. Showing the drives in conjunction with the preamps, and in comparison to one another is really helpful.

@solal94 Ай бұрын

the purple bass is beautiful !!!

@contratoronto5868 Ай бұрын

Really appreciate how methodically Ian demos each setting with slightly different gear to really show a good sampling of how each setting can affect the tone in tandem with the gear

@JETallacksen Ай бұрын

Such a good video! I've learned quite a bit about my Super Vintage and Cali76 Compact Bass. Thanks!

@jermainelong1843 Ай бұрын

The P Bass tone was off the hook!

@n_phaneuf Ай бұрын

When this is on your board with the HX, where is it in the signal?

@gigifara9312 Ай бұрын

best pedal ive ever bought

@crimsontowerfullmoon8646 Ай бұрын

Really so cool

@johntdoherty7469 Ай бұрын

What is that one delay pedal

@CNCTEMATIC Ай бұрын

Its awesome that you feature a pedal from a competitor for the benefit of your customers! In the manual for the Revival Drive compact, you recommend setting the Lows pot at zero for a Vox sound, yet here, for the same job, you set it at about 75%. I wonder why. Which is better for a Vox sound?

@pimcramer2569 Ай бұрын

So slow attack and fast release for funk?

@OriginEffectsUK Ай бұрын

typically yes

@bazZzment Ай бұрын

Wow, what a great video! Great playing as well! 👌

@michaelfloyd4917 Ай бұрын

Thank you for including plenty of clean sounds!!! Thank you also for having Jack play, put that man on the payroll!

@blackonebass Ай бұрын

Excellent content! It helped me a lot with the tones on Pbass and JB

@TheRealJayguar 2 ай бұрын

Straight forward explanation appreciated! I will use this as a reference as I continue to learn this

@KyleS.1987 2 ай бұрын

Bookmarking this for when I get my hands on one of these. I love what compression does for bass, but don't understand it well enough to come up with my own settings. Maybe playing around with these will help me get it.