I've done a site tour of our Window Factory and you absolutely can get more than 90% fill of the Argon. Do you factor of our dual pane is 0.27

Yay, it totally worked. Thank you

9 times out of ten there is no argon gas in the window , they can't ship it to a different elevation with argon in it , most of the time they will need to send them with breather tubes in them we pinch off after installation. The higher the elevation, the more the glass will expand, and the lower the elevation, the more the glass will suck its self in . Window glass insulated glass is atmospherically sealed .

your really not Fixing Seal Failure are you now, you replacing the failed unit

Thank you!!

Thank you, I fixed mine with the first tip

Thank you!!!!

You are actually spot on! No need to use names RBA… also known as Refusal By Anyone! I was just at a home today and the clients mentioned that. Clearly it is a company with no sense of integrity. They are over priced liars that prey on people’s fear!

Thank you so much for this!! Saved my window from being open!

watched your video for 2min and was able to fix 3 windows in the house, thank you sir!!

Adjusting the keeper was what worked for me! Thank you!!

I heard a noise then couldn’t close my window looked up how to lock it and this was the first video and within the first problem he pointed out I was able to lock my window again super great video

Thank you so much! I fixed it!

Thanks!

Dead ass I didn’t think it would work and this vid was a waste of time but it actually worked 10/10 vid

Thank you so much senior live alone windows wouldn't lock, pushed tp windows were closed and they locked ❤

You're a genius!! It worked. Thanks!

I have several new windows that slide slowly different amounts. How to address this?

Thank you for this video. You are a lifesaver. Couldn't figure why my window wouldn't lock. The first solution was what fixed my problem. Somehow the top part of the window moved down a little bit and prevented my window from locking.

so this means the low e is on the inside of the glass and not the outside?

Bro thank you so much

This help sooooooooo much thank you sir.

First one fixed it.. thank you!

This was super helpful and fixed my issue! Thx so much!

Interlock did it, thank you.

Thankyou for the information my friend referred me to your channel. And your absolutely right about that boat payment.

My top window had popped inward so it wasn't going up all the way for the locks and latches to line up. Thanks

Thank you for fixing my window!!!!

Then you!!!

Wtf are you talking about? Every fiberglass windows are screwed and glued. You make no sense saying EVERY window is welded and it is no big deal when people are paying over $2k a window for a screwed and glue leaky fiberglass windows. Now 5 or so years later after getting screwed and glued fiberglass windows costing over $2k a windows $60k a house full of widows that are leaking in the corners because fiberglass windows are screwed and glued in the corners instead of welded which fiberglass cannot be welded.

Thank you!! My top wasn’t all the way up. Would never have thought of that.

I’m furious. I told my contractor I wanted good windows and he gave me air filled crap with a .44 U factor. He was mad at me when I told him to not install and he better order the better ones or I’m not paying. Might have to go to court.

What if the condensation on the windows is freezing?

This actually was helpful, problem two was the reason why!

Thank you !!!

That first one absolutely worked. You're the best.

We had these windows installed in our house and it was a huge mistake. The viewing area (ie the glass) is much smaller than our 25 year old windows by a couple inches on all sides and the vinyl is much bigger. They told us that was to make them more energy efficient, but that is far from the truth. These windows make our house colder and some part of the vinyl can be 15 degrees colder than the wall temperature. I do not think the vinyl in these windows has any insulation. If the glass took up more of the window they would be a lot better Do not get these if you live in a cold environment or you will regret them like we do!

Still in 2024 your video still help

is this only for a tilt out window?

yeehaw!! I just fixed my window because of you!!! I thank god for you, sir. Tonight, I'll sleep in peace

I love you

You didn't FIX anything! MUMBBLES!!!!

awesome video

most common problem was our problem thanks for the video!

What do you do when it takes moderate force to get the bottom half all the way down, but then top half (which had been all the way up) suddenly jerks down once when the bottom half hits the bottom, ensuring that both halves will not be fully closed simultaneously?

Interesting and helpful.

Ultima finestria

Can you make one about Ultimate Finestria in Canada

I literally just spent $48,000 on windows off of a 3% more argon gas window than the other company I almost went with 🤦

Holy expletive! I thought the top portion of these windows was fixed. 7 years later... thank you! One of my two major energy efficiency issues fixed.