Жыл бұрын
Жыл бұрын
Жыл бұрын
Жыл бұрын
Жыл бұрын
Пікірлер
@TishaRicks 8 сағат бұрын
Can R-28 be used in vented crawlspaces?
@David_FixIt 5 күн бұрын
You put the only one layer of insulation? It will be enough? I asking cause My customer asked about two layers
@BattleOfNewOleans 5 күн бұрын
The question I have isn't, do termites eat mineral wool? They don't eat rigid foam board either. My question is do termites burrow through mineral wool as they do RFB to get to wood?
@sydrider6023 8 күн бұрын
The wires are not supposed to be left with an air space allowing the heat to escape??
@gabrielwhalen3382 10 күн бұрын
this was super helpful.
@jefftillman4772 13 күн бұрын
Can you post a link to where you can get those resilient channels
@mestiza1776 14 күн бұрын
Is this method used only on a pitched roof? Could it be done on a gabled roof?
@jasonwells131 16 күн бұрын
Can I do the ROCKWOOL on the interior of the roof deck without the exterior roof insulation. I’m in Florida.
@ROCKWOOLNorthAmerica 15 күн бұрын
Thanks for your comment! Our technical team would be more than happy to assist you with this matter. You can email them at [email protected], please provide them with some more information and they can certainly help with this question.
@jimcurtis569 21 күн бұрын
Your PPE looks weak. Are neck gaiters and non enclosing safety glasses really what's recommended by Rockwool?
@ChristopherParrillo-x4t 22 күн бұрын
I’m doing something similar, floor above is just decking, no subfloor. Can I use rigid foam as thermal break, more readily available in my area and do I need a vapor barrier against underside of decking?
@mchristopher 22 күн бұрын
You need a vapor barrier on the warm side or you will get mold in the joist bay and dry rot eventually too. The foam board would be a good vapor barrier if you cut it smaller that the joist bay by about 3/8” all around and fill the void with canned spray foam. Then fill the rest of the joist bay depth with roxul or fiberglass but don’t add another vapor barrier by using fiberglass batts with tar paper. That would be a vapor lock and cause mold/rot. Roxul would be the best imo added to the sealed foam board. It’s super easy to work with. I think the comfort board is overkill if you do the foam board and roxul. Then just cover it up with plywood.
@CoasterCrazyy 11 күн бұрын
@@mchristopher excellent answer, only thing I could add is make sure you are using 2inch foam board, anything less wont count as the vapour barrier
@TheBestYouthWrestlingVideos 28 күн бұрын
Window installation before roofing? 🤔
@TedNarolski Ай бұрын
No venting needed for crawl space?
@PhantomCurve Ай бұрын
The useful material in this video could have been condensed into 90 seconds.
@h2s-i9o Ай бұрын
Just over roof with tji
@bobf1174 Ай бұрын
Available in a 8’ wide bat and 14’ long?
@LtGrimms Ай бұрын
When it says "attach drip flashing" @3:10 how is the flashing attached? Double sided tape?
@williamheimsoth4156 Ай бұрын
I'm hoping to use this product in the roof deck of my metal building. I will squeeze r30 comfortbatts between my 2x8 trusses. Does it need to be covered on the bottom? Will it rain down dangerous particles if left exposed?
@ROCKWOOLNorthAmerica Ай бұрын
Thank you for reaching out with your question. Our Technical Services team would be the best resource to help answer all your questions. The team may have some additional questions for you in order to provide the best recommendation. We recommend that you reach out directly to them at [email protected]. They would be happy to help!
@vegtamvanderveg Ай бұрын
can rats chew through it?
@southbendkid Ай бұрын
Rockwool has been around for over a decade yet comfortbat is only sometimes at Lowes in limited sizes and comfortboard is hardly available at all. I needed a limited amount of comfortbpard for a project. I resorted to an acoustic systems company. Material and shipping cost was insane.
@ROCKWOOLNorthAmerica Ай бұрын
Hi @southbendkid, we are sorry to hear this was your experience with our products. We acknowledge your concerns about the availability of our products and the challenge of securing ROCKWOOL stone wool for your projects. We assure you that we are working hard to improve availability and meet the growing demand. As part of our efforts, production is increasing with all lines running 24/7. Thank you for your understanding and patience.
@leeknivek Ай бұрын
i would use hardware cloth or wire mesh to hold that in, especially if it's outside. that stuff will crumble apart!
@MrTenkara Ай бұрын
No need for two staggered layers?
@johnjuran7270 Ай бұрын
How does it dry out under 15 mil plastic
@johnjuran7270 Ай бұрын
How does it dry out under 15 mil plastic?
@h2s-i9o Ай бұрын
Dont use zip if your using rockwool on the outside. Use henrys water proof blueskin and forego the rainscreen. Rockwool acts as a rainscreen.
@h2s-i9o Ай бұрын
You should be gapping your rockwool and sprayfoaming the joints too
@kianpanel-ci4gv Ай бұрын
does this cost a lot? cause ive seen people saying that
@kianpanel-ci4gv Ай бұрын
Ceilings looks great
@TheGodfather101 Ай бұрын
rockwoll doesnt do dick for low frequency
@CashNYC Ай бұрын
what other R rating can u use?
@Distorted_views Ай бұрын
Rip his longs should've worn a mask when working with green death
@kianpanel-ci4gv Ай бұрын
time consuming but this is really intresting
@VillelaHN Ай бұрын
Thank you for sharing this series.
@3HOLYBULLS Ай бұрын
Understood
@ChrisDarjany Ай бұрын
Did you do anything with the ceilings or floors for sound transmission? Or just the walls? I’m loving this series🎉
@ROCKWOOLNorthAmerica Ай бұрын
This series does not cover those applications specifically, but if you check out our channel we have plenty of content regarding those applications. We're glad you're enjoying it, thanks for watching!
@kianpanel-ci4gv Ай бұрын
where can i buy rookwool
@kianpanel-ci4gv Ай бұрын
in my opinion glass wool is a lot better to work with
@bingwong9454 Ай бұрын
Does rockwool mice resistant? Thank you.
@mchristopher Ай бұрын
How to you cover the roxul after you’ve installed the batts and the Comfort Board? Thank you!
@ChristopherParrillo-x4t 22 күн бұрын
Did you ever get an answer to this?
@sydrider6023 Ай бұрын
You need to seal the gaps before any insulation is applied.
@mapsuiv 2 ай бұрын
Merci bcp 🔥🔥🔥
@shyonemami7388 2 ай бұрын
terrible video
@gregcharland 2 ай бұрын
Wouldn't it been more cost effective to over frame with 2X4 lumber and insulate with high density spray foam? Same R-Value with added structural benefits.
@JoelWeyrick 2 ай бұрын
@gregcharland Search for Asiri Designs about foam. Rockwool is a much better choice.
@LogHog22 2 ай бұрын
What kind of fasteners are being used in this video?
@DeuceDeuceBravo 2 ай бұрын
Rockwool is fantastic stuff but at current prices it's a luxury item.
@tsaipod 2 ай бұрын
Aren’t you creating a water dam by putting those boards stood up on edge running perpendicular to the roof slope? This also does not allow the rockwool to drain if it gets wet. Do I have this wrong!
@Xonikz Ай бұрын
Yes, if this is sheathed over the toenailed members, it should be ok though.
@g_dubbe 2 ай бұрын
What is the difference between the grey "self adhesive flashing membrane" at1:30 and the"pink/red "flashing tape" in this video?
@jpeterson991 2 ай бұрын
How much of a gap do you need to leave between insulation and subfloor on a ceiling ? My John’s mansville product says make it tight
@carolerouquier4801 2 ай бұрын
Bonjour, attention aux protections. Ça pique les yeux, la peau et c’est dangereux pour les poumons ! j’ai mis cette laine et suis très satisfaite de la réduction du bruit. Apres je n’ai pas fait comme ça. Le plafond de ma voisine du dessous est beaucoup plus desolidarisé que cela & pour mes cloisons, j’ai mis du fermacell bcp plus lourd que le platre.
@LogHog22 2 ай бұрын
Anyone have a Comfortboard 110 supplier?
@davidwiley652 2 ай бұрын
To be honest, this was a useless video. I was looking for Sheetrock being cut and installed. I hate camera trick videos where nothing was showed.
@MHTwigg 2 ай бұрын
Sir, I watch a lot of videos you produce. I'm going to be using this on a small install and just wanted your thoughts on the negatives I've heard on VOCs and possibly breathing in fibers when installing... do the binders fail? as over time, years later... That's my biggest worry and of course when installing. I use a wheelchair, so I'm close to what I'm working with.