Mine is doing the same exact thing., I’m gonna clean them tomorrow thank you so much

Would thiS for a 2017

For a Buick Vernon 2015 do I do the same thing in the video

2018 high country. Had this issue damn near going on here freeway. Gonna clean the battery terminals, cables and ground wire.

Omg I literally just changed my shift knob watching ur video. I have a 2013 Buick Verano . THANK YOU❤

So how do you fix it?

I just about went this route.. but after watching some dyno videos comparing the same 5.3 with stock manifolds vs Shorty headers vs long tubes, I decided to just stick with a new set of manifolds. Shortys just don’t change the sound much and minimal power gains. Long tubes will give you the better sound and best performance but I’m not putting long tubes on a daily driver so the sensible conclusion was stick with the manifolds

Changed the battery lead cable only and all is good . 😅

I'm installing these on my '05 Silverado Z71 5.3 Ext cab once I get them. Ordered them today be here in a couple weeks!

Thanks for sharing,

I’m pretty sure that is the wrong bushing. The correct bushing looks kind of like a bucket with a handle on top.

I have mazda demio 2004, i have the original remote key, i changed batteries, does this work on this?

Thanks for getting straight to the point and doing a great job explaining the process. Most DYI videos/influencers feel they have to tell a whole life story before getting straight into what’s being searched. Kudos to you brother.

Any issues with the O2 sensors at all??

Thanks for actually showing how you used the pry bar. I wish I had found your video before doing the work on my truck. Just installed 2" RC N3 lifting struts on my 2014 Sierra (4wd). I only loosened the tie rod end and sway bar end link to provide a little more play. You can remove and reinstall the struts without taking everything else apart. HOWEVER, you will have a harder time as you will have to force the old strut out and the new one in. Ultimately, I ended up jacking up the bottom of the strut just a bit while pounding out the lower mounting bracket with a 2-3' piece of 1" steel pipe. To install, I jacked up the bottom of the strut and used a pry bar to pop bracket into place. If you don't want to muscle it out and in the way I did, then spend the extra time to disconnect everything. At the end of the day, this is a nice ride improvement over the Rancho strut and spacer puck I had.

You gave absolutely zero good information here, you could explain what needs fixed not just say that needs fixed, well what about the people who don't know, because the people who do know ain't going to watch your video

Video is a life saver. Couldnt get it on for like 2 hours last night. Came across this video this AM and found out the yellow part was just a clip lol. Thank you sir

Is your truck 4wd? I'm having problems finding headers that will fit my sierra because it's 4wd

Thank you, I got my refrigerator working

What diameter are these 1 5/8 or 7/8

This just happen to mine today and did everything you described. Luckily it finally gave out in a parking lot of my work. I will be trying this and hope that’s all it is! Thanks you posting that!

Great video.

My car is 10 years older but I'm going to try this. Thanks that was simple and helpful.

where did❤ you get the van ? thanks

Do i use the washers on the new stud bolts ? Or with put washers

Does anyone know what the middle clip on the driver side is called ? Mine broke and need to get another

Hey buddy I checked the ground under the passenger and cleaned it up and the on the dash with the insulation. Is there anything else I could try ? Still having issues with the cluster flickering and service airbag and and theft alarms constantly poping up.

Thank you!!! I'm going to do mine, along with the axle shafts.

My 2017 silverado completely shut off when turning right at a light this morning. The steering locked up, no brakes, no electrical, no engine. Thank God nobody was on the road or i would have caused an accident. Sprayed wd40 on the grounds as soon as i parked. Its better already but going to clean them after work. 4-27-24

Did these work with the stock spark plug wires?

This happened to me today

I am having the SAME issue. Changed my calipers, rotors, pads, and I still get hard pull to the right. Did changing that brake hose fix your pull issue??

Thank you! Great video helped me fix the service light on my truck in less than 10 mins !

My 2009 gmc Yukon did the same thing. I put it in neutral and turned key and started back up. I bought a thicker gauge ground wire to battery terminal. Still waiting to see if it does it again. Gmc and chevy suvs known for this. 👎

This should be a recall item GM... About lost it because of loss of steering lol its electric with a shoddy grounding setup. Gonna fix it myself for good but they need to do a recall before this gets someone killed.

I just diagnosed this issue today. Thank you for the video. I knew it had to be an easy fix. I just wanted confirmation.

Just replaced mine thank you for your help

i bought the same set of headers no matter what donut gasket i use even with some high temp rtv it leaks at the collector any tips? i’m at my wits end with them

I’m so thankful I found your post. I’m going to have my husband look into this ASAP twice tonight my 2015 GMC Denali died while turning to the left slowly it’s super scary. Any idea if this solution would help with my radio randomly scrolling through every option available? Sometimes it works great and then sometimes it just does whatever it wants. I also have gotten to the point of thinking of trading this truck in, although I like it in every other way.

i’ve been having this exact problem ! tomorrow morning i’m going to go an clean that ground wired .. hopefully that fixes it case this things really stressed me out

So I had this code on for a while now and came across this video and finally came around to checking and it’s disconnected! But the only thing is I can’t find the actually connector. I know it sounds weird but I literally checked everywhere around the area for an hour and no connector. Do you know exactly where the wires come from?

That’s so funny same thing just happened to me I am shitting myself 😂

It is the perfect trick

This helped us

Music got to go man !

Just had this same thing happening to 2015 Suburban so went and had my cables replaced no issues now

Like the video?? Buy me a coffee cash.app/$pb2715

Good knowledge 👍

2017 Chevy Tahoe here, I bought a new battery and still did the same thing. I’m gonna try cleaning that ground bolt. Wish me luck.

Why the fk are you using a 12pt impact socket? No wonder it didn't work