1-2 inch Shackle Drop on my 1978 c10. Finally leveling her out.

Today I got an itch to drop the rear end of my Chevy square so I decided to put together a quick video on the best way to get it put on. I purchased the part from Advanced Auto Parts for just 50 bucks! Y’all check out the install and i hope this helps someone somewhere! Enjoy and keep building!

[@127bits7]

stud. this is the exact video i have been searching days for. tip my hat to you sir.

[@coryreynolds5217]

Found ya brother

[@bradclure3742]

Seen you going down i20 the other day. Truck looks good.

[@jack_knife_customz2966]

You put the flat side to the rear right? I seen peoples videos where they put the flat side to the front.

[@coryreynolds5217]

Do you think it will work the same on my long bed. It looks like your shackles our little bit further back than mine

[@Geoduck.]

Cory, my long bed is like yours and yes a typical 1 - 2 inch drop shackle will work fine. You will not need to cut a bed rail its simple job. Check around the prices are all over the place and look closely and buy one well made. Suggest you spray all four bolts with a quality lube several times over a week or so before you attempt to remove them.

[@papasolecustoms]

It should work homie!

[@barberyuh6075]

What kit did you use in the rear to make them discs ?

[@127bits7]

What exhaust are you running on this beast? It sounds excellent.

[@ethanwise8919]

Could I get a shout out I r the one from TikTok that does the lives at 5 I follow u