1964 5.5 HP Johnson Impeller and Service Part 1

I show how to change the impeller on this 1964 5.5 hp Johnson. I also change the lower unit oil.
The impeller part # Johnson/Evinrude Impeller 434424
Subscribe to my Channel:
/ musherdeeds

[@holmgrown]

Thanks that was a great help I see my fun is just beginning

[@goprovideos2022]

hi! thank you for this video^^ merci beaucoup grace a vous j'ai reussi a demonter l'embase de mon evinrude!

[@billratliff3265]

www.vintageoutboard.com has a lot of parts for pre 70 marine engines. Purchased a complete water pump rebuild with power head gasket for around $40 for the same engine as in this video.

[@MusherDeeds]

+Bill Ratliff I got mine off of Ebay I think.

[@keithmorris341]

Any reason after doing water pump it wont pussy water

[@musicislife6802]

Lol u got a bit of a spelling error there bud, if you have to the exact engine and did a water pump but it's not pumping make sure the metal line went into the water pump housing when you put the lower unit on, if it's still not pumping you could have something blocking it, check the thermostat, but other than that I would have no clue

[@dfwfishfeen8909]

😂 😂

[@johnlaw7278]

you don't have to take the power head off

[@minimoments7039]

What do you do then? I'm struggling getting mine off 🤔 1963 5.5hp Evinrude fisherman. Thanks

[@psstplease]

Power head has to come off on these mid 50s to mid 60s motors. Omc switched to a shift linkage clamp in the lower unit in later models...made life much easier