1970 Chevelle restoration part 1

[@j-ridecustoms]

Thanks for sharing it’s nice watching someone else doing it for a change lol

[@dette-envers-les-animaux]

If you want to protect this car and be definitively efficient against rust , you should put grease everywhere. grease is the only thing very efficient against rust. put grease between metal and carpet, inside door, behind metallic bumper, under the vehicle, behind the repairs you can make (everywhere inside the body - hidden erea - instead of using paint), hollow areas (necessarily hidden, so no need to be aesthetic). For rear wings unreachable with a paintbrush, use an extender and pour old oil everywhere each year. Rust almost always comes from the inside and welds. Handyman Experience - 35 years. From france

[@Chevelle-cc6xf]

You mentioned at 11:00 you are going to screw it down to move it over. Could you please go into a bit more depth. I am having the same issues with my chevelle. The quarter panel wants to get tight at the end of the trunk pan.

[@harringtonclassiccarrestor8674]

The tail panel goes up under the quarter and we just needed to screw it in to open the gap. Sometimes you do have to cut the quarter or trim the trunk lid to get the gap right.

[@a4000t]

Some of these aftermarket doors/panels really fit bad.

[@harringtonclassiccarrestor8674]

that is true. i have found the fenders fit the worst. not much trouble with the doors. and had a few quarters not fit 100%

[@buffsheeri]

Amazing you can get body panels for this old car but they have major problems with new vehicles.

[@harringtonclassiccarrestor8674]

Starting to have a hard time getting these panels also.

[@cristobalnegrete6545]

Approximately how much has it cost up to this point of the restoration?

[@harringtonclassiccarrestor8674]

About 5 grand with parts.

[@Psycopathamania]

@@harringtonclassiccarrestor8674 this was about 5k where are you located?

[@harringtonclassiccarrestor8674]

@@Psycopathamania we are in Asheboro NC

[@markt9438]

What happen to Part II ? You guys make it look so easy ! I will be doing some !

[@harringtonclassiccarrestor8674]

Just haven't had time to do part 2 yet. Thanks. I'll try and get on it soon.

[@jasondelo4354]

Would it be more cost effective to just buy a full body from dynacorn? Only reason I ask is cause I’m debating that route

[@harringtonclassiccarrestor8674]

Not sure how good they are. I have done Camaro bodyshells and had to do a ton of cutting to make the mouldings fit

[@larrytidwell4395]

what is the copper color coating?

[@harringtonclassiccarrestor8674]

Weld through primer. Sometimes it's grey also. It's supposed to protect what is welded.

[@justinthomas937]

is there a reason you do your doors and quarters before the floors? Im doing a 72 and started with the floors and will work my way out. Great work!

[@harringtonclassiccarrestor8674]

No reason why I did it that way first. Sometimes I do floors first. Like I did on the newest video. The 69 Chevelle.