2.0t WORST EVER 4 cylinder Oil Filter / Oil Change PLUS OIL extraction vs drain plug result Audi B7

[@garys7410]

Been doing extraction method on my audi a6 and mercedes e400, the trick is is to not push the hose all the way in use the biggest tube to make a complete seal around the dipstick tube about a inch down. After only 6 or 7 mins all the oil comes out. If you use the smaller tube and push it all the way down only 60% of oil will extract I remember first time i attemped extract i was not impressed but watched another video shows how to properly extract. One great thing about both vehicles the filter is on top no need to go under!

[@starflite3]

My A4 B7 is 3.2. Cartridge filter on top. That little 4 cylinder and that's the best place Audi could find for a filter location. Crazy.

[@NitroVipers3]

Dude in the audizine forums says his oil extractor got stock deep in the engine... that scares me. He had to take the pan off tie fix it. Id thing an oil extractor would be good because it would poke and break up that sludge and suck it out also. I cut a hole in my belly pan so I can change the oil without taking it off.

[@Drumwolf62]

I have had those kind of days man!! Its like everything just goes wrong. You kept your cool and continued on man!!!

[@ramonovazquez4351]

I got the same engine. Next time loosen the filter housing then from the top place a ziplock bag around the housing and take it all the way out - no mess. Clean the housing, put new filter and screw it back. I believe that that I have a oil leak from the oil filter housing and have to replace the gasket amount other things like intake valve cleaning and timing chain replace with the tensioner.

[@DMB0956]

Other than using the extraction tube improperly and claiming you have to remove and replace the filter from underneath, it was perfect.

[@skipsterz]

Thx for demonstrating this! I will continue to drain plug my OC’s on my EA113 since I have to get under the car for the filter change anyway. Really not saving any time. Get my main oil drain pan under the plug while I drain the filter into a separate smaller one.

[@BuckRogers20011]

I’m renting a VW Jetta right now. It has the 1.4T I believe. Anyway, I noticed that the check oil level light was on a few minutes after we left the airport where I picked it up. My wife called rental car place and told them. They said we never send a car out low on oil and he said it’s probably just the altitude.😀so I reset the light and said let’s see if it comes back. And 20 minutes later it came back on. So I had my wife call them again and let them know we reset the indicator and it came back. Same response. So I drive a couple hundred miles the next day. No issues light still on. Anyway, as I do not know how low it actually is I decided to go to Walmart and bought a qt. Of Super Tech 0w-20. I put 1/2 qt in and light turned off. Now I can use it w/o worrying about spinning a bearing. This is why I never buy rental cars.

[@richardhkennedy8262]

You can buy a screw on hose to drain the oil filter before removal.

[@3kkk514]

I had the same engine with my a4 b7 2.0tfsi what i did when removing the oil filter , from the top just place a small bin bag to the surrounding of the housing filter then remove it, allow for few mins and just a little wipe then install a new one no oil drip on the floor.

[@craigjennings9034]

I’m looking forward to the transmission flush video.

[@garys3958]

Should have given you my special drain hose for the oil filter that I still have from when we had a B7 2.0t. Makes no mess using it.

[@ericbloomquist9040]

plug and filter housing drain FTW, actually makes VERY LITTLE mess

[@rayj33]

I have this but it's more headache to use than cleaning the oil mess. I usually don't lift the car during oil change. 19mm wrench, 1/2 ratchet+36mm socket+wobble/swivel adapter+5 quarts 0w40

[@ericbloomquist9040]

@@rayj33 i can connect my drain from the engine bay without lifting the car. easier than a mess IMO

[@EXOVCDS]

LOL... Diaper for the undercarriage!

[@80sGuy.]

Waddaya know, it's Thomas EXOVCDS! Enjoyed your work. Great to see you here bud.

[@80sGuy.]

1:49 You don't need to jack the car up to get to the oil filter from the bottom. It can easily be reached down by the side of the engine.

[@samosity123]

For such an experienced mechanic, you had a very bad day!

[@mejiaaldo]

That's a great video you got a great sense of humor made me laugh.

[@jempoof]

I cant believe you didn't put a drain pan, just to measure how much still came out. Plus the floor. Of course the vacuum wont get it all out.

[@toledotom57]

he lifted the car on the right side away from the drain plug. There is a small depression inside the pan to help aid the removal. when you put the car in level position any remaining oil collect down near the drain plug. Oh, well, I got a good laugh out of it!

[@sebastianlorenzo4935]

What happen to the transmission fluid change. Looking forward to that.

[@Drumwolf62]

Dude you are looking like Chevy Chase does oil changes!!! Very Entertaining!! : )

[@dougn2350]

Oh... This was meant to be entertaining. Not for serious DIY car maintenance

[@onlyoneromeo]

A lot of those oil extraction tubes aren't thin enough to go to far past the dipstick tube and get to the bottom of the oil pan.

[@toledotom57]

Looking forward to the Transmission flush and see how many quarts end up on the floor? You spent .35 on oil absorb, .25 on extra soap to clean your clothes and at least $4.75 on brake clean and $2.00 on shop towels plus and extra 45 minutes in clean-up? I am thinking the plug on the bottom of the oil filter unit was missing due to not tightening it down properly. Similar to a Lexus where a platic pop bottle can be pushed up and realese and remaining oil in the filter holder and NOT cause a big mess prior to removal? Might help to maybe remind yourself next time! Lmao

[@Drumwolf62]

Awesome you even have Audi advertising. Love those new Audi's man!!! :)

[@Drumwolf62]

Hey alright I use ECS Tuning as well!!

[@Drumwolf62]

Wow you are like the flash dude!!! :)

[@ElT1greVerde]

magnetic drain plugs! and filter magnets :D

[@todor92]

All B7 2.0 tfsi should be with timing BELT, no chain. 2009+ year (B8) and newer models are with chain

[@NaptownTuner]

What drives the exhaust camshaft if the timing belt only drives the intake camshaft gear?

[@virtisconsole12]

That was the loudest valve chatter of whatever upon starting that up.. wow what was that? I hope no damage. Never heard any generation of the 2L Audi’s sound that loud. I remember something about one of your other videos about not changing oils , so if an oil like mobile 1 which meets VW502 is used should I stay with that oil? Or will ANY VW502 approved oil work? Also thoughts on adding rislone or amsoil oil additive as the 5th qt? What about adding MMO to the motor, in your experience what is best to keep the rings clean?

[@admk2500]

ive found that that does not happen if you start the car with oil in the filter and crank the engine a few times without letting it start up.. then start it up...

[@CarlosAlvarado-wq9of]

its the glasses for me really 😆

[@burimhajredinaj5538]

Hello , I am trying to contact you maybe we can do some work on my car I have a 2015 vw passat , looking to replace my engine or maybe just do valve seal due to oil Consumption

[@Steelhorse-enthusiast]

I have this car winter is setting in now the car has developed a knocking on cold start / morning only doesn’t knock any other time recently had oil change 5w 30 with a new oil filter anyone god any ideas what to check

[@bigpapichino1342]

Hey nap, im in need of a turbocharger for a 2013 a4 quattro 2.0T ASAP. My wastegate is bad. Can I buy one off of you if u had one in good condition laying around? Thanks man!

[@mr.feathers8697]

Why 0W-40 and not 5W-40?

[@meeterhead462]

That is the dirtiest engine bay ..

[@jackc244]

Is valvoline an audi approved oil? I know its not for VW...just asking

[@bl8ed930]

Use either castrol, shell 5w40 or Liqui moly

[@jempoof]

You just did that filter up too tight i recon. They are such crap housings. I do them up by hand till the stop and use no tool.

[@Official_bigtango]

Day 1 asking for turbee mod videos

[@ontheroadproductions3956]

This man must hate Audis 🤣

[@dougn2350]

I don't hate Audi but I certainly dont envy their owners. I actually feel kinda sorry for them. They usually aren't mechanically oriented

[@NitroVipers3]

Better get out the Oil absorbent granulars

[@laundrieshanging9077]

lol clicking n clacking because it oil wasn’t system primed before startup -_-

[@NaptownTuner]

You prime engines for oil changes? Tell me more

[@ianwarriner8193]

Typical yank ,a drama out of a crisis 😂

[@matbuchanan9765]

No more wake & bake before filming your video's brougham...

[@ardadincsoy5809]

Just take the plug off in the first place!!!! You are making a mess for no reason. Such a silly video 😂