2005 Jeep Liberty CRD fuel injector installation, fuel system priming, water pump installation.

In this video I install and prime the fuel system and install the water pump on my 2005 Jeep Liberty CRD.

[@funnyman540]

I wish I knew about your channel 6 months ago. My jeep is still in the shop after a failed injector all the way in the back. The mechanic just can't seem to get the injectors to stop leaking and parts are really hard for him to get. I probably could have fixed it myself.

[@owenbooth658]

Ik my stock one stuck open would do some weird shjt if you was 2300 rpms getting on the highway it would bog out but everything else was fine

[@andrej9983]

supr ok

[@beinthenowmedia7638]

Noooo, where is a video 8?

[@onparfait5921]

What’s the torque spec for the injector hood downs? Thank you for the video

[@CMYTUB]

Sir do you have a pictures of all the ground points in this vehicle? I have a P0299 since March 2021 ( I am writing this in July 17 2021 )!!! I Fixed the ground below the driver side headlight, and the smoke and driveability improve a little, and the boost when i press the pedal come, go and then come and do it like normal. By the way i have good maf and map. New Vacuum solenoid, good cac hoses and airbox to turbo hose is new and i have the cat removed. Maybe my problem is that i need to drive it hard many times, what do you think? thank you.

[@summeryoung8]

I have same code on my 2006 crd. It cuts out under load. Cleaned map sensor. May change a injector