2007 JEEP WRANGLER JK 3.8 IDLE PROBLEMS FIX!!!

What causes Idle problems on Jeep Wrangler 2007

[@CFoss09]

The sensor in the beginning of the video is not a mass air flow sensor, it’s a intake air temperature sensor, just for future reference 😉

[@cockasorrus7475]

Great job troubleshooting. Usually if you have a low M/cyl. & no leaks at the calipers. It might be the seal at master cylinder leaking in the booster. 🤙🏻 Sometimes if you have cruise and have a vacuum leak you can’t find it might be the brake switch for C/C.

[@marcosmtb7983]

Muy bueno el vídeo amigo, muchas gracias

[@RolandStLuce]

Very informative

[@craiggolden7072]

Thanks for the info!

[@argonaut119]

Nice description. But you should video the repair work as you are doing it. Otherwise, it just becomes a lecture. Advice: Actual work on video really helps a lot more than just talking about it.

[@jorgeluisortiz75]

Thanks!

[@andyschuldt7580]

I had to change both on my 2007 but it was because of poor braking. I too had brake fluid in the booster. Good video. Thinking when you cleaned the throttle it caused the code. Probably unrelated to your idle issue.

[@queensapphire7717]

When I changed the stock spark plugs in my 2010, at 59k miles, 2 of them were just about only hand tight.

[@kastas6008]

Jeep 2007 Red light comes up as soon i start the engine and RMP goes up & down and finally vehicle turns itself OFF. I changed throttle body, Thermal sensor, accelerator paddle, water valve still the problem remains. Please advice. Thanks

[@thunderjet4294]

Hey bro these issues are common on Mopar my 5.7 had the same issues replaced the throttle body started stalling after had lightning bolt ended up doing a re learn on the throttle and it works like new

[@CristoferMagana]

Those map sensors do not have any holders that’s how they came from the factory

[@mobaker1040]

im having the same issues but was wondering if when youd let off the throttle while the jeep was having those problems would the rpms bounce and did you ever get a fuel rich code?

[@jeeping7878]

I think i did i check every evap hose ,change sensor try e throttle still did at the end it was my brake buster it was leaking,if you press the break and heard a hiss noise that it keeps on going you got a leaks

[@jeeping7878]

My jeep will do that ..and it was running like crap i shut off and start and runs ok but it happens when i was on a traffic light for too long .. check your buster for leaks ,and if its when you pull your brake buster check if there is some break fluid in it , if there is change the master cylinder if you don’t it will damage your new break buster

[@Jamaicanbacon30]

Bro I really wish u did the work and then did tutorials. It’s hard just listen to you without work. My Jeep is having th same Issue. I am Confused on how to fix it.

[@blakefindley2936]

My jeep just got red lightning bolt on dash and it’s like it’s in limp mode it won’t go past 30 it idles really riff like a exhaust Leak or vacuum leak I cleaned the throttle body and it still doing the same thing

[@jeeping7878]

Check your buster if it leaks or evap leaks

[@jeeping7878]

Brake busters

[@alfredodoe3445]

did u end up finding the problem?

[@rednecksame5506]

I have the same problem, can you help me?

[@Jamaicanbacon30]

How can I get it fixed

[@pennyhelga3628]

My Jeep ran good until i took it to the dealer . They ruin it to keep you coming back . So i got rid of it .

[@queensapphire7717]

NEVER have work done at the dealer, except warranty work. They are known as as the “Stealerships” for a reason, find a good, trusted local mechanic, if you cannot do your own regular maintenance. Do not use oil change places like Jiffy lube, they’ll destroy your vehicle.

[@eesko2000]

I really don’t think the Brake Booster has anything to do with How the Jeeps idles ?

[@jaedendavies9465]

Might have something to do with vacuum.

[@Jamaicanbacon30]

Doing ur video as u work would help better than showing after

[@jakeowens1770]

Pulling teeth