2010-2015 Camaro SS - Gulfcoast Driveshaft Installation - Phastek Performance

[@anibalgarcia7296]

I would also like to install GULF COAST DRIVE SHAFT 3.5" 1350 SERIES ALUMINUM SLIP SHAFT, MANUAL TRANSMISSION 2016-2023 CAMARO SS, which I saw on the PHASTEK page

[@juniors.m3]

Just finished installing mine😈

[@josephgagliardo6088]

A Couple things that should be mentioned here, Gulf Coast recommends that you use the factory torque specs not just tighten down. Second check for clearance once installed not all cars are exactly the same and some do rub, you may not be able to reinstall the heat shield either. Get yourself some torque wrench adapters you will need them for proper install.

[@PhastekPerformance]

Thank you, We did point out that the driveshaft rubs on our Instagram Page. We did clear the heat shield.

[@danrez42]

Is there a performance advantage by making your car muffler delete thank you

[@anibalgarcia7296]

Hello. Good afternoon. Have you not made a video installing the engine bases of the Camaro SS 1Le 2016+ part MM-010 from BMR Suspension or are you aware of a video of this installation? Gracias. Also if you know of a workshop to install MBR products for a 2023 or 24 Camaro, installing: MM010, TCA059, UTCA058, CB008, DTB005, STB019, SP041, DSL019, ELK015, TR007, CB009, SB049, WAK361, UTCA061. and also install exhaust parts, Mishimoto cooling liquid expansion tank and oil collection container.

[@modernmusclecar1904]

Hi there do the original rubber bushings get removed as well. Thanks

[@Frankenstein6.2]

what is the HP rating on these?

[@PhastekPerformance]

The manufacturer does not provide an exact HP limit but we have seen these drive shafts on very high HP builds. Also note the T8 Aluminum used on the 4" is roughly 20% stronger tensile rating than the T6 aluminum you'll find most other manufacturers use.

[@teke237]

I’m getting a slight humming above 30mph and very tiny bit of vibration . I’m wondering if it’s my driveshaft. 2014 Ss supercharged with the stock 2 piece …..

[@Aphillip0617]

It’s that middle Bering probably

[@rankymasunu3145]

Where are you guys located?

[@PhastekPerformance]

Hey @rankymasunu3145 ! Our home office is in Houston Texas