I used dealer products only. Parts was about $120 bucks. Saved myself some money by doing it myself.
Пікірлер: 12
@87jpatino Жыл бұрын
Thanks for the video, very helpful! For the DIY’ers I give this Pcv/hose replacement a 8/10 Rat Bastards. Only because the transmission tube is in the way of the upgraded orientation of the Pcv valve/Pcv hose, and the other end of the hose is very hard to reach, you either use a flexible hose clamp remover with cable extension(recommend), or remove the upper plenum. Cring tip, I had to pry the transmission tube just enough out of the way so that I could fit the upgraded hose on the upgraded valve orientation. Some vehicles with same type of engine may be different. Vehicle I worked on 2012 dodge Durango SXT V6.
@jimrusch22 Жыл бұрын
2018 and newer Pentastar 3.6 V6 engines have a different PCV valve. They twist off rather than the flange mount depicted.
@PadareArt2 жыл бұрын
Your video helped me a lot...that valve sure is a rat bastard.It was very frustrating but I got it done...Thanks!
@jesusurena164611 ай бұрын
Thank you so much
@strat30uttalasht683 жыл бұрын
What problems did you have that you had to replace it
@MaynardFreek4 жыл бұрын
My 2012 wrangler has even less room to work out the pcv valve
@mangoguey3 жыл бұрын
Great video it took me ages to find someone that did this engine with the pcv in the back. Also thanks for the tool recommendation!! If you would have done it differently what would you have done to make it easier?
@bennieleija58463 жыл бұрын
Bought a Ford
@jimd36434 жыл бұрын
Great video! Did the dealer inform you about the new or upgraded PCV valve and hose?
@jfloydsea4 жыл бұрын
Same terrible placement in my wrangler JK.
@rubennunez2087 Жыл бұрын
I just did it it took me 4 hours I'm pretty handy when it comes to changing parts but I have to admit this job is far far from easy