This video shows you how to set the timing chain intake and exhaust cam gears along with the crankshaft. A future video will show them when they are set correctly.
Пікірлер: 14
@metrork12 жыл бұрын
To set timing chain, the exhaust sprocket, one nearest the fire wall, you will find a rectangle punched into the sprocket if it still original there will be a little blue spray paint found there. That mark is lined up with the chain. The intake sprocket, side closest to the radiator, you will find there are two groves, choose the grove to align with that has a dot on the face. Of course line the lowest part of the chain lines up with the dot on the crank sprocket gear. Important: Once all marks are lined up place the rear timing chain guide in place and wire it up to the upper timing chain on top so that the rear timing chain guide has tension on it so keep the timing chain from jumping a tooth when placing the timing chain cover in place. It has a tendency to jump a tooth on the lower crank sprocket if this is not done. Recheck your marks before bolting on the timing cover. Once cover is bolted on..then remove the wire you put in place earlier. Load the tensioner and insert and bolt it in place. Turn engine counter clock wise till you hear a click. Check by poking a screw driver against the rear of timing chain to see if slop in timing chain is gone. Have a good day!
@brianmorgan60392 жыл бұрын
Do you have to take the head off for the timing chain? I'm just about to get started on mine. It's a 2014. What manual did you use to help you?
@SidewaysGts2 жыл бұрын
I know this comment is 8 moths old, so potentially less for you and more for anyone else who may be curious if they cross this question: You wont need to remove the cylinder head to do the timing chain :)
@Grahams-Grass6 жыл бұрын
What happened in the end???
@ccobra68133 жыл бұрын
That is a horrendous amount of sealant coming out of the cover. That stuff comes loose inside the cover and plugs up oil ports.
@kurtwallrath14364 жыл бұрын
How many miles was on your Prius when you decided to change the timing chain? I’m asking because I want to know when to change mine.
@AdamDeVries4 жыл бұрын
I only removed the timing chain because I had to change the head gasket. The head gaskets seem to blow at about 180k miles on the gen 3 Prius
@SIMPLEGUY4233 жыл бұрын
Chain don’t fail right
@Megacatares2 жыл бұрын
@@SIMPLEGUY423 mine seems fine I'm re-using 250k miles.
@metrork12 жыл бұрын
@@SIMPLEGUY423 The head gasket will.
@eddiepadilla10782 жыл бұрын
Hey, I dont think you have enough silicone :)
@kami0093 жыл бұрын
i am sure if he started the engine with bad timing his valves are destroyed
@leeroypana79204 жыл бұрын
bad video shooting. I even cannot see the location of the timing chain box relative to the engine