2024 Triumph Street Triple - Brogue Low Profile Turn Signal Install

[@graysonwolf1216]

Thanks! That silly plastic grommet connection had me flummoxed and it literally took 10 seconds once I had seen your video. You're a star.

[@Georgethedog11]

Nice guide. Everyone should make sure to test the turnsignals immediately after plugging them in.

[@ridepastu1418]

Thank you sooooo much, showing panel removal. I see your bike is leaking/sweating oil on the left side of the block/head.

[@TimothyBoyden]

No, no leaks. May have been residue from a puddle.

[@lateralus9244]

Did you have to change the blinker relay to prevent any hyper flashing?

[@TimothyBoyden]

@@lateralus9244 Nope

[@rgbstudi]

Hi! Good video! I've the same bike, in cosmic yellow, and now I bought the same windscreen as you, the problem is that to installing it, I've to remove the small plastic piece in front of the TFT, but I can't find the way to do it, I tried removing the headlight but I didn't find how to do it. Did you installed for yourself??

[@TimothyBoyden]

Sorry, I had the shop install the flyscreen as part of the purchase.

[@realMysta]

Was tightening the nut a pain on install?

[@lampingromeo]

Use the regular nut supplied, not the nylock nut included as it’s very difficult to tighten. The regular nut supplied is easy with a socket on the inside and an Allen outside.

[@Ventcis]

Could you just pull the Fairing without taking out that plastic grommet?

[@TimothyBoyden]

Not on the 2023 that I had. The plastic rivet holds the red plastic fairing in place.

[@Ventcis]

@@TimothyBoyden Thanks. Could you recommend how to pull the fairings? Do you just pull only or you have to squeeze it somehow as well?

[@TimothyBoyden]

@@Ventcis Just pull. Didn't take that much force to do so once the rivet is removed.