3 1/4 Inch Trolling Motor Lower Unit Disassembly & Assembly | Minn Kota

Subscribe for more Minn Kota How-to videos! bit.ly/35DiLAX
www.minnkotamotors.com

[@smacinskyjr]

How much of that nose cone is solid? If I needed to trim off 1/2 to 5/8 of an inch is there enough material there to do that? Or is it pretty much hollow with the exception of the potting material?

[@davemilster]

Very nicely done!

[@fisherlism8774]

I can't take out ARMATURE. I think bearing has rust with BRUSH PLATE W/HOLDER. Do you have any idea?

[@stevequate1797]

Wished someone would do a shear pin rusted into shaft of armature!!!!mine is rusted in so bad I can’t hammer it out, I flattened the shear pin so I ground it flat very slowly abs carefully, nothing is easy on a salt water anything, guess I’m going to free have a new shear pin hole.

[@robertlang8200]

where can i buy the brush spreader tool

[@rw2421]

Following