350z Lower Ball Joints DIY Replacement, G35 and Maxima Lower Ball Joint Replacement easy to do!

Today we are replacing the lower ball joints on my 350z which should be the same for the G35 and maybe even the maxima as well. As far as ball joints go, these are actually some of the easier ones I've replaced. Pretty easy access and hardly have to remove anything to get to them. This job is made pretty easy by the ball joint press which i'll link down below.
As an Amazon Associate I earn from qualifying purchases
Ball Joint Press: amzn.to/3zeYAYj
Ratchet: amzn.to/3pKHHk0
Cotter Pin Remover: amzn.to/3cvhIra
Snap Ring Pliers (quality set): amzn.to/2GNOAhW
Ball Joints (x2): amzn.to/3v6TVEv
Service Manual: amzn.to/3BdY8dR
To donate financially to the channel via Paypal:
www.paypal.com/cgi-bin/webscr...

[@AGuyandHisProjects]

As an Amazon Associate I earn from qualifying purchases Ball Joint Press: amzn.to/3zeYAYj Ratchet: amzn.to/3pKHHk0 Cotter Pin Remover: amzn.to/3cvhIra Snap Ring Pliers (quality set): amzn.to/2GNOAhW Ball Joints (x2): amzn.to/3v6TVEv Service Manual: amzn.to/3BdY8dR To donate financially to the channel via Paypal: www.paypal.com/cgi-bin/webscr?cmd=_donations&business=5PRRGY4GM2CSE&currency_code=USD

[@handsomemarco29]

It's way easier the way you done it than other videos were showing ..I didn't want to undo all bolts on lower control arm. Thanks for sharing 👍

[@AGuyandHisProjects]

Glad I could help!

[@NKillmore]

These are Underrated well done! Youre the only person who didn't take off the lower control arm.

[@AGuyandHisProjects]

Thabks for watching and the comment! I try to do things the easiest way I can lol

[@mescobar8801]

Did you grease them?

[@mescobar8801]

Just wondering because I installed them but didn’t add any grease

[@AGuyandHisProjects]

I don't remember at this point haha. If they are greasable then yeah, I always grease them. If they are sealed then no, you don't have to

[@kazuma5408]

Great video! I’ve seen a lot of people Remove the entire knuckle or the lower arm etc. i like this way the best. Did you have to disconnect the upper arm from the knuckle?

[@AGuyandHisProjects]

Thanks! I left the knuckle attached to the upper control arm the entire time. I'm all for removing stuff to gain better access, this situation however it is not needed. Let me know it goes when you tackle it!