6F35 Zip Kit

[@shoes121255]

I saw your other video regarding the vehicle not moving after 15 min. Did fixing the clip fix the problem? What are your thoughts on the transgo version of this product?

[@CurmudgeonTransmission]

Yes. I have used it also. Works good. Having said that. Right now you can get both halves of the vb from Ford for about the same price. But you will need to reprogram it with the new solenoid strategy.

[@prburkhardt]

On the zip kit instructions at insert 6a for gen 2 it shows replacing the accumulator piston, short with a spring, it shows a longer piston on the same picture. You don't toss the longer piston next to the short one do you?

[@CurmudgeonTransmission]

No. it is for the Gen 1 only. DO NOT replace it with the short one. Leave the long one in there.

[@prburkhardt]

Thanks@@CurmudgeonTransmission

[@johnlangeveld3392]

Did the Zip Kit solve the problem? Make the shifting smoother?

[@CurmudgeonTransmission]

Yes. These valve bodies are horrible about wear. Check with your Ford dealership beforehand. As sometimes you can buy the valve body for not much more than the kit will cost you.

[@johnlangeveld3392]

@@CurmudgeonTransmission In your opinion, is trying to install the Zip Kit too difficult of a job for an average joe?

[@johnlangeveld3392]

@@CurmudgeonTransmission 2014 Ford Fusion -- Delayed 2-3 shift. And clunky shifting overall.

[@CurmudgeonTransmission]

No. I don't think so. Especially if you are mechanically inclined.

[@johnlangeveld3392]

@@CurmudgeonTransmission Thanks for the insight. Appreciated!

[@mikegggg4089]

Hi my ford transit connect 1.6 stall when I put drive or reverse Is that mean bad torque converter?

[@CurmudgeonTransmission]

Could be. Could also be a bad solenoid, valve body or computer.

[@joeabels3931]

Tom would it hurt the transmission if I left the valve out put the cover on and idle the car in park? want to flush it with out the value in it.

[@CurmudgeonTransmission]

It is not going to start. The neutral switch plugs into the plate and the wiring harness plugs into that.. Why do you want to flush it like that?

[@joeabels3931]

@@CurmudgeonTransmission make sure no junk is in it. I already took the valve out was just wondering if it can be done.

[@CurmudgeonTransmission]

@@joeabels3931 That is what the filter is for. I would just drain it and fill it back up. There is a plug in the bottom of the transmission, 7/16 or 11mm, pull it out and let it drain.

[@joeabels3931]

@@CurmudgeonTransmission I was just wondering. That is fine I'll put the valve back in and run it then. Thanks