6L80e Connector Tutorial

[@FieroWipeout]

Thank you, this is exactly what I needed. Thanks for the short and informative video. Chasing down an intermittent p1825 in a 2007 Escalade ESV.

[@ep2653]

THANK YOU THANK YOU!! I just spent half an hour trying to get this piece out. 🤘🏼🤘🏼🤘🏼

[@thewolfethatdwellswiththel6020]

Thank you brother. Spent quite some time trying to figure out how to unplug it.

[@bpautomotivellc]

No Problem!

[@msanford8741]

Good video. Anyone know the number for the terminal release tool?

[@autorepair2023]

Thank you so much know I have idea how to get back my truck on the road again 👌

[@raulhernandez9511]

Can u help me i have the wires for at 4l60 n i need. A adater for A 6l80 conveshn sorry about the spelling were can i get

[@lizardgeneralconstruction9439]

Do you sell it or where can I buy it? Mine broke.

[@TheSchadenfreuda]

Thank you so very very much for this video!!!!

[@shanecarender9051]

My pass through sleeve came out with the external plug. Now I cannot get the sleeve off the plug to reinstall in the transmission. Any advice?

[@bpautomotivellc]

You have to remove the TCM to get that to seal properly when you install the sleeve!

[@carsurvivalist]

Got the lock out. Blew connection with compressed air. Tried disconnecting and lever broke. Tried rotating again without lever with no success. Any tips for removal?

[@bpautomotivellc]

make sure the white lock is pulled before trying to twist!

[@TeguhJayanto]

Thank you bro👍👍👍

[@brakestar4157]

Dumb question. But what if a pin broke off in the 6l80 and maybe removing the back of that pin to an unused pin and soldering the new spot to the old spot and depinning harness to the new spot because the 6l80 only uses 12 wires so the other spots in the trans dont go to anywhere.

[@bpautomotivellc]

You will have to replace the TCM inside the transmission!

[@85brewski]

I think this may be my problem. 2010 ss Camaro . wont take any gear forward or reverse shows park on dash in any gear. going to double check it tomorrow.

[@codya8684]

Also make sure the plastic twist piece is fully seated back into the valve body after removal or it won't connect either

[@lowkey_35G]

Thank you

[@johndao4660]

i broke lock