1998-02 HONDA ACCORD: CV AXLE REPLACEMENT

[@Iamtherodlight1453.]

Thank you sir. For taking the time to make this vid.

[@charlesReed239]

Thanks for posting this. It really helped out today. Cheers my dude.

[@Maderasdesign]

I'm so jealous yours came out with no issues. I've been fighting mine for hours!

[@Usmanthemecano]

Jack up the car high enough to get a good size prybar on it or a chisel and hammer

[@Maderasdesign]

@@Usmanthemecano finally got it out! Thank you so much man. Your video is so appreciate!!!

[@edwardgomez5616]

@@Usmanthemecano I've taken them out with a small chain and a 2x4. I looped the chain around the axle and put a bolt through the chain to keep it tight around the axle then took the 2x4 and twisted the chain around it, then snath it about 2 or 3 times and voila it comes out. I had a camry that I couldn't get a snatcher around and couldn't get it high enough to get under it with a pry bar, so I thought of the chain and bolt idea. Also, I learned that both wheels have to be off the ground,nor you can snatch on the axle forever, it ain't coming off.

[@ianmacgillivray2740]

Liked the video, could hardly hear the audio, other than the power tools!! Keep up the good work.

[@Usmanthemecano]

Yes unfortunately that camera doesn't allow for external mic...

[@drewdzsf]

Thanks 99 accord only guy not using all the best tools lol I did the sxle

[@kcisthe1st]

Thanks for the video audio is definitely lacking but very helpful 🙏🏿

[@Usmanthemecano]

Thanks for watching

[@del01k_]

My car jerks when I put it from park to drive. Will this replacement help that problem?

[@Usmanthemecano]

Maybe. Check the engine mounts as well

[@Jason_Phillips3679]

After the new one is installed do I need a alignment ?

[@Usmanthemecano]

Not usually unless you took apart things not shown in the video

[@maurice2014]

What size socket is the axle nut? Thanks in advance.

[@Usmanthemecano]

Toyota are usually 30mm

[@Usmanthemecano]

Honda 34mm I believe

[@booitsnick]

36 mm but if ur tired of the bullshit I used a angle grinder and cut off wheel

[@charrohernandez6835]

Do you have to do alignment after doing this ?

[@Usmanthemecano]

Na

[@charrohernandez6835]

@@Usmanthemecano thank you for the reply. Is it better to replace both or just the one that is damaged?

[@Usmanthemecano]

Just the damaged

[@tooflessproductions.8296]

What size socket did you use for the axle nut

[@Usmanthemecano]

Sorry I don't remember.

[@TedTremendous]

36mm, torque front to 180

[@tandaman008]

Brother if those are harbor freight jacks take them back they have a recall. Don’t trust them.

[@Usmanthemecano]

Did it long ago but thank you!

[@Toast.420]

Rip this fools break line 😂why you playing around with it like that .