To take out main gear, you need to take out opposite side small snap over the handle bearing. That snap is to hold bearing in position which is little tricky.So it will give you some room to move around main gear to take out. Good luck
@wswsparks4542 Жыл бұрын
The reason you can't get the gear out is a annoying little wire clip on the opposite side. I couldn't even get it out with picks I had to sharpen a paper clip lol
@MarkyBoyle9 ай бұрын
I can't get my anti reverse working again. Uggghhh
@rontruocchio57442 жыл бұрын
wonderful reel but not built for salt water fishing. mine started to bind up and i never dunked it. the drive shaft bering got rusty and scorched the sleeve going through it to the rotor. i cleaned it up but have to keep an eye on it . while it was open put extra oil on the berings and extra grease on the gears
@f4fishing5102 жыл бұрын
Informative ❤️
@IAMGWH12 жыл бұрын
There should be a retainer wire on top of the right side bearings holding the drive shaft of the main gear, remove it & it should come out easily!
@mohdfirdausabdrahman74202 жыл бұрын
This video helped!
@cfaadventures3280 Жыл бұрын
Could I get some help, I have a daiwa crossfire LT reel and I recently took the bail arm off to clean it and now the bail arm will not close all the way and keeps lifting up a bit
@finnafishfl2 жыл бұрын
Is there a gasket on the bottom of the drag knob
@Simon_Lado Жыл бұрын
yes
@buysell35157 ай бұрын
What sizeis this reel ?
@M.Redsky3 жыл бұрын
I am interested in an ultralight reel, and need your guidance. Which has more value: the Daiwa Revros or the Okuma Ceymar?