Aprilia procedure: how to properly bleed rear brake

The only and best way to properly bleed the rear brake of your bike

[@larryliddiard4246]

This is the only procedure that worked out of all the other methods i tried... worked right away the first time. I just used a metal bar in between the caliper after i took it off instead of an old rotor but it works all the same. I also used a mityvac pump as well.

[@jagertroop]

Great video. I have tried a few other methods (traditional, and reverse bleeding) and nothing has worked very well. Reverse works way better than traditional, but it was still a bit spongy. I broke down and bought a vacuum bleeder and it worked. I set it up just like you have it, and the result is a rear brake that actually stops my bike. Thank you sir.

[@NicovanderSteen]

YW !!!! great to see the feedback on my vids !

[@jeremyr62]

I'll try it this way but I reckon you should also elevate the drain pipe to the vacuum pump. I think you will see then you are pulling air around the threads. Grease around the nipple can stop this (sometimes).

[@maartos]

Clear video

[@maartos]

Using it again lol

[@nigelmitchell351]

I am never convinced that small air bubbles are not getting past the bleed nipple threads. So before I start I always put PTFE tape around the thread area of the nipple to make a seal.

[@DonGH97]

Smart!

[@hehehhh]

great videos you have on the aprilia bike, what size is the wrench for the bleeding screw on the caliper? (can't measure atm) *facepalm*

[@NicovanderSteen]

Thanks ! I think it was 10 or 12 mm

[@jagertroop]

11mm

[@hehehhh]

yep it was an 11mm already did the job but thanks! :)

[@MikaHakkinen83]

8mm in the front caliper and clutch

[@hawkins2211]

Try bleeding my brake 7x 660 motul No matter what I do it wont work New caliper 2x New line 2x New pump 3x

[@maartos]

Was ik weer... misschien toch maar andere pomp met klauw kopen