ArcDroid Cut Clip: An example of torch bobbing. What's the solution?

[@jasonkemp140]

For your designs what do you use to draw them up with? Is there templates that you use to help with making the artwork?

[@amp_mechanic]

I mostly use Fusion360 sometimes I use Inkscape. There are some free dxf's, svg's, clipart etc. out there. Some I've bought off etsy.

[@davidcat1455]

Beautiful finished product. I must admit I’m a little confused, do you have the torch height control permanently installed now? Or are you still experimenting?

[@amp_mechanic]

The answer is both. Yes, I do have it permanently installed but there are certain things I've been changing periodically so I can help others and better convey the key points to pay attention to when trying to get THC to work. If I would have run around 1600mm/min THC would have less bobbing in and out of the sharp corners.

[@davidcat1455]

@@amp_mechanic Cool. Thanks for the information. Still trying to figure my Arcdroid out. Technology passed me by and I am struggling,to put it mildly. Nothing wrong with the machine, everything wrong with the Operater.😃

[@amp_mechanic]

The learning curve with anything CNC is steep but it will start to make sense.

[@davidcat1455]

@@amp_mechanic Yes I figured that. I completely resisted technology until about three years ago when my sister bought me an iPad. I didn’t even have a mobile phone relying solely on a landline. i’ll figure it out.😃👍