Arcdroid: Making a splash with some more cuts and layouts.

Just a CNC Plasma video of a couple new pieces for customers using the ArcDroid.
If you've found this information useful and would like to contribute, now you can at www.buymeacoffee.com/ampmechanic

[@davidcat1455]

Beautiful work.👍

[@Mikefestiva]

Thanks for making these videos 👍 I was wondering if you have used the mirror feature at all. I have tried it on my Arcdroid and it doesn’t seem to work right. It just takes the drawing and moves it to the other side but doesn’t retain the original drawing. It’s more of a (flip drawing) then a mirror. Any suggestions would be appreciated. Thanks.

[@amp_mechanic]

Hi Mike, I have not used it so I'm not much help on that one. But it may depend on where your origin is set.

[@amp_mechanic]

You could email ArcDroid and I'm sure they will give you the rundown on it.

[@Mikefestiva]

@@amp_mechanic thanks for getting back to me 😊 as far as I can tell it looks like you need to cut your part, then mirror it and cut the other half. It gets a little strange with the start and stop points though. I was excited about this feature but as soon as I realized it’s not working the way I thought it would it became almost a useless for me. Thanks again for all your videos on the Arcdroid 👍

[@ravenhhca]

Heads up for Alibre users. Their CAD does not support plasma

[@amp_mechanic]

Good tip.