Audi A6 Quattro Valve Cover Gasket, Wires, Cam cap Replacement

1998-2004 AUDI A6
*Tools Needed*
6mm 10mm socket
screwdrivers
picks
prybar
pliers
17mm, 14mm, 13mm wrench

[@J4rn0]

Very nice video, thanks, whats the cover bolts torque spec and are both gaskets the same?

[@PhillemonRongwane-fj9bj]

Hi My name is phillemon matsomane I manage to remove this

[@jonrylander461]

Did you have to take off the timing belt cover? Another video I saw said you needed to do that. I'm doing this job right now and started taking out the headlights which is a royal PITA btw so I can take off the timing cover but if that's not necessary I would like to know. Thanks for the video man, we need more people like you!

[@darwinmorocho1145]

liked the content, i liked the step by step and how you were saying what size tools you used and where the bolts where located

[@818getta]

The place of where you got the replacements would be good. A website or something. Good work.

[@Hardts]

Followed your guide, had the exact same problem in the drivers side (cyl 4+5+6). Now fixed, hopefully that does it. Thanks a lot!

[@miramontes1983]

what was the car doing that made you replace the gaskets. were there any lights showing up in the dash board. was there any syptoms.

[@ecanixgarage1106]

Alex Miramontes if I remember correctly it was leaking oil externally and possibly had a misfire from a spark plug hole filling up with oil.. could of possibly had a check engine light if it had a misfire but that is about it. Mainly oil leak

[@miramontes1983]

the oil light wasn't going off. wats ur opinion if the oil light goes on while driving

[@jacobwiley3215]

well done sir

[@jegnyholwijn3492]

Good job brother

[@MoNsTeRbEaSt65]

what did you torque it down to you never said and I need to know

[@ecanixgarage1106]

MoNsTeRbEaSt65 the valve cover itself?

[@MoNsTeRbEaSt65]

ECANIX GARAGE but is it like 7 ft pounds of torque or what cuz I can't find the specific torque

[@MoNsTeRbEaSt65]

yeah the valve cover

[@ecanixgarage1106]

MoNsTeRbEaSt65 I don't usually use a "torque" spec on valve covers so I'm not sure. If it's an aluminum head then no more then 8-10 ft lbs. 👍🏻

[@MoNsTeRbEaSt65]

ECANIX GARAGE thank you I been trying to figure it out but I'll just do that and the video was very educational

[@damontracyvis1017]

Bad advertisement. Not a 8 but a 6

[@joycealbrecht1353]

Can you read??? Need new glasses?