I got hooked up the design aspect by watching 2 of your videos.
@Shiva4D3 жыл бұрын
Wow. I just working on similar idea. Very elegant construction.. but, your model with shift back and front on focus. Its Ok if you have autofocus.. but.. not so good if you model dramatically change size of final image.. your model quality will be as worst as smallest(far from cam) image.
@reborneuk3 жыл бұрын
Thank you :) Agreed - I do use autofocus on mine so I allow 5 seconds between movements just to be sure.
@dekahobby3 жыл бұрын
Can you video make step by step print part & arduino setting?
@reborneuk3 жыл бұрын
Hi, I've got further information on the settings on the Thingiverse page - there's only the settings for number of rotational stops and vertical stops that you really need to change, other changes would be down to the camera you are using, and unfortunately I just have the experience of the two cameras mentioned. I've no plans for a printing video, as that's just your usual 3D printing technique and I'd be going over ground covered numerous times on KZbin at a better level than I would be offering. Many thanks!
@JakubKnyziak2 жыл бұрын
@@reborneuk just a question on your 3d printer model / setup would be amazing!