Watch as Bert Baker removes the stock 5-speed transmission from a 2002 Road King and prepares the Bike for the all new DD6 (Direct Drive 6-Speed) gear set.
Пікірлер: 14
@CORVAIRWILD11 жыл бұрын
Cool beans... Nice commentary... A little college education goes along way. I can tell you've done this before, gears and seals and snap rings are flying! Part II tonite! Can't wait!!!
@goodboyringo97169 жыл бұрын
Baker is bad ass !!!
@obfuscated309010 жыл бұрын
My machinist buddies admire Baker parts, which says a lot as they aren't bikers and had never heard of Baker before. Throw up some videos for installing your simpler parts too. I don't need them but they will help other customers. I'D LIKE TO SEE A BENT BAKER KICKER ARM IN STAINLESS STEEL. It should sell well. I'll buy three at least. Bent is the most common style and after buying two straight stainless Baker arms for other applications I feel dirty running mere plated steel. Even good chrome is still chrome.
@richardmcgeorge26747 жыл бұрын
do a video on removal of 6sp harley as they differ
@toddflowers80528 жыл бұрын
Can that trick be done just to remove the inner primary race? If so can you just dead blow hammer the main shaft back into place with out any damage to bearings etc.?
@1Stopvocalshopping9 жыл бұрын
I have a right side Baker OD6R 6 speed that is leaking oil, how many hours does it take to replace the gaskets?
@Koko-qq8ji6 жыл бұрын
Nice vid Bert, but you forgot to remove the needle "cup" bearing that the counter shaft sits in on the left side of the case.🙀
@thomaspeariso56226 ай бұрын
I have a thunder mountain with baker 6 speed rt drive, my 3rd gear jumps. Do you have a upgrade gear set that I can change out for this trans. Bike has a 300 tire on back ?
@1GOODBROKER9 жыл бұрын
Mr. Bert Baker, my ratchet pawl seems to have broken on my Baker 6 speed trans. I can attempt to shift gears, but it just moves/turns and doesn't not actually shift the pawl on the inside of the trans. I opened it up and it appears that I have to take apart my entire bdl belt drive that I have to access the trans in order to take apart the entire trans to replace the ratchet pawl that seems to be broken. Am I correct to assume that I have to take apart my entire trans in order to change the ratchet pawl? If so do you have any recommendations on tools and the best way to replace the ratchet pawl. I purchased it in 2005. Its a baker 6 speed. I think I paid about 3k-3,500 in 2005. You have a great product and I will continue to use baker on every one of my motorcycles and tell everyone I know that Baker is the only way to go!
@leelizardwilcox62717 жыл бұрын
Why don't you guys do an install vid of your Baker XL6. Lots of sporty owners would like it
@chrisbioski45773 жыл бұрын
Do you use the same clutch as a 5 speed?
@tomtrail46873 жыл бұрын
Is that a evo motor or twin cam
@hedrick45092 жыл бұрын
deep throat socket lol
@travissultze9344 ай бұрын
I had to replace my trap door because the Baker one was warped I replaced it with the Simon your guises are thin just like the Harleys wish they warp and flex