Big Dent popped with boiling water and ice!

[@oracanter8520]

that sound that the dent made when it popped was so satisfying

[@bigbang4540]

Your amazing thanks for sharing, its people in the world like you who make the world a better place.

[@robertcampbell5605]

its fake

[@samouflage99]

That popping back into place seemed like we were watching the dent go back in time with the sound and everything

[@desienamreeka2804]

Im doing this to mine, that pop up sound baaam 😅 good job!

[@jsanregrets]

You are the only one smart enough to know the hot cold Contraction method works with bigger dents. The morons testing it with dry ice are doing it to small hail dings holding a tiny piece of dry ice for a second then can't believe it didn't work. Get the spot of the dent very hot then stick a block of dry ice and hold it there and it will pop out or do it with the hot water and ice water method like this guy did. Dent needs to be big enough to contract.. Good video showing it works.

[@abrahamlopez2707]

so your saying this same method does not work on small dents??

[@Isummerfresh]

I've seen many videos where people just used hot boiling water and a plunger or pop a dent devices. No ice was needed.

[@Jcoope2409]

Does it work for all kind of bodies because some makes are different?

[@JDsgreatz28]

U should tell Yuri to get out of the trunk now lol

[@adrianvargas9784]

Yuri! Bahahahahaahahahah I see what you did there lmfao 😭💀💀💀💀

[@dboutdoors6180]

You can still see the damage on the bottom and top of the dent, his camera angle and lighting hide the damage. Put it outside or with better lighting and you will see the crown on top and bottom are still there.

[@life0ftiti]

Shut up

[@greg_d]

That dent was so large, and in a place where it could have been popped out from the inside (the trunk in this case).

[@stranraerlad1]

Hi Mad4 I take it the water was just off the boil ? Would there be any problem with the paint on some cars? It's just I have a 1.5 inch long dent on a door of my Renault and was a bit wary about the high temperature. Thanks anyway for another great vid.

[@Mad4Motors_]

yes just off the boil if its deeper u might need a plunger, (yes a plunger) will work!

[@stranraerlad1]

Mad4Motors ok thanks no the dent is only a couple of mm's deep it can hardly be seen ,depending on the Iight direction

[@elsey1976]

Mad4Motors quit lying to people! Obviously was pushed out from the guy in the trunk

[@andrewstones2921]

@@elsey1976 I was going to say the same... but only as a joke!

[@stephensmith9258]

Brilliant really clever and helpful thankyou

[@SuperSm1th]

yer a harry, wizard

[@GPerformance]

WTF! Nice!!!

[@reallifestories1077]

I think this is called thermal expansion! works great on cars

[@angelokollias9749]

I love this guy

[@TusciaVieta]

Would it work with small dent, about 6 cm diameter?

[@danielul05]

Is this a magic trick?

[@TimothyWestPhotography]

That was awesome 👍

[@TheMississauga333]

way cool, you sounded suprised lol

[@christopherpittas]

DOES THIS ACTUALLY WORK??!!

[@Brooke-v2i]

would this work on tiny dents?

[@nahimibrahim107]

Who was in the trunk pushing?

[@MollyMcBooter]

will it be safe to do on a small shallow dent right above a tail light? I know the metal can handle it but im afraid of the plastic tail light cracking 😬

[@matthiasweigel311]

Take the tail light out first...

[@kevinc6073]

I have a index finger thick dent on the top of my trunk. Will this method work???. I believe it was a hail that caused it.

[@JRH087]

No very doubtful

[@martinaguilar1977]

Is this really true? Can anyone vouch for this? I have a few dents on my car

[@toneloc9084]

Depends on the dint

[@myakkafuel9574]

I find it very hard to belive too but i guess their us a possibility. Like u said someone is in the trunk. Not that it realy matters.

[@CERTI0151]

Science my friend

[@joshbrookes6439]

Nobody is in the trunk mate, lol

[@cassandrahagerman4361]

@@joshbrookes6439swear

[@blackalligatorstudios]

WTF! Nice job!

[@abrahamlopez2707]

does this work with small dents aswell?

[@fearedafghan5911]

Try it first and then report back

[@proxykvi]

Is it metal or plastic part?

[@Mad4Motors_]

Hi this is metal

[@SvetlanaDenisoff]

Cool! Noted. I hope I will never need it, but cool method!

[@smarte.r.1450]

I have a similar sized (if not smaller) dent in the bonnet of an Audi Al. You think it would work?

[@TobiasSaibot87]

Maybe I should try this. I have a dent on my trunk lid where it is at a crease point

[@jean-michelgauthier4804]

Whouaaaaan C'est...(*;*) Magique..!! Merci merci.(°:°)

[@damd1985]

🤣 yup someone pushed the dent from inside... Lmao the second batch never touched the dent.

[@liamconnolly9233]

you clearly don't understand thermo dynamics, hot water cause the metal to expand, the ice water causes the metal to shrink, hence the panel pops

[@somestuffithoughtyoumightl6985]

@@liamconnolly9233 the science is sound, but the application was poor. Cold water never touched the concave part that required contraction.

[@robertcampbell5605]

lol yea someone is on the inside of the trunk and pushed the dent out. the ice water barely even touched the car when he poured it.

[@tmastervlogs1222]

Do you have to boil the cold water

[@motorcareireland5919]

Satisfying

[@hippydude1]

Omg Haha. Brilliant

[@blackhawktv1156]

It’s not working even for asmall dent

[@sendheron1]

Wow😲amazing👌

[@yungboichaplin1948]

Why is this funny?

[@finai2381]

That pop.....so sxc

[@davidsnyder8730]

There's someone in the trunk of the car

[@regoat]

Wow it's work

[@ahmedalmaashi2839]

😅👍👍👍👍👍👍

[@ricardopaulino4170]

This is bullshit he wasn't even pouring the cold water in the car someone was in the trunk all the time . I do the same job but I do it the real hard working way

[@rogeroliver3919]

Ricardo Paulino Seems you're working too hard

[@paul8028]

The way the boiling (or hot) water pours is different than the icy water. He almost doesnt touch the dent with the cold water.

[@15岁少女惨遭4名老师轮]

nice job