Brushless Losi Aftershock / LST on 4s

Brushless Aftershock, HobbyKing 120A esc, Tacon 2150 motor, Turnigy 4000mah 4S Lipo, 25/66 gearing using THE DUDES single speed hub. Top speed of 76mph. Losi brushless conversion. Switched some things around for weight distribution. Anything bigger than 4s is uncontrollable.

[@AvgDan]

Can the correct parts to do an electric conversion for the LST XXL be purchased anymore? I'm not having any luck finding a kit.

[@kjsmolik]

I actually took this POS aluminum wheelie bar off and installed the Losi wheelie bar. The Losi one is way better.

[@kjsmolik]

My next brushless conversion will be my Savage Xl. Any advise would be good. Going with the same motor and esc combo with Kershaw designs motor mount and a universal battery tray. . No clue about gearing. Thinking either 15/44 or 12/44.

[@danielhill5746]

hey man I did the same thing with my aftershock but with a mamba monster 2 what did u use for a wheel bar.

[@critixizer]

LOL the end where u almost hit ur boy

[@daddyhammons9519]

How many teeth on the motor gear

[@rambohernandez115]

how much cost to make brushless?

[@kurtsmolik6585]

Its the Aftershock body

[@12BPAPI]

How did you attach pinion to motor?

[@kjsmolik]

The gear has a set screw

[@12BPAPI]

What do you mean it has one in the front so do i have to run a motor with a shaft that has a hole in the end?

[@kjsmolik]

No the shaft on the motor has a flat spot where the set screw tightens against.

[@12BPAPI]

Is it the stock pinion because there's no place to put a set screw on my stock one just like it except in the end. I've had other trucks with pinions that go like what you're talking about with the flat spot when you tighten the set screws on the side or round part of the pinion.

[@kjsmolik]

No it's not stock..