Рет қаралды 68
In part 2 I show to use a polyurethane clear coat on the freshly stained workbench that should help to protect it from oil and grease. I did two coats and did light sand in between to get a good bonding surface. Almost forgot to mention the worst part, I had to shim most of the top of the table to make it level. I guess this is due to the wood not being completely straight since it was all old and free. In the next episode, I start to finish up the garage
Time Stamps:
Coming Soon
Disclaimer:
Due to factors beyond the control of Mello Motorsports, I cannot guarantee against improper use or unauthorized modifications of this information. Mello Motorsports assumes no liability for property damage or injury incurred due to any of the information contained in this video. Use this information at your own risk. Mello Motorsports recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Mello Motorsports, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss resulting from improper use of these tools, equipment, or from the information contained in this video is the user's sole responsibility and not Mello Motorsports.