C6 Corvette Intake Porting and Port Matching LS2

C6 Corvette LS2 Intake Porting and Port Matching.
In this Video we walk through porting and port matching an Ls2 Intake. This can also be used for and LS3 Intake porting and Port matching too.
Attempt all work at your own risk. The publisher bears no responsibility for improper or unsafe repairs, injury, or damages to property that may result from your work or this video.

[@ramon23598]

What are the results?

[@acuracy00]

When you put your manifold back on and went through the re-torque sequence, did any of the mounting posts start collapsing/mushrooming over on you?

[@KevinJonesYouTube]

No not at all.

[@acuracy00]

@@KevinJonesKZbin two of mine did. No support ribs on the LS2 manifold like all the other LS manifolds

[@philiperickson5182]

Why not use the gasket or do you port that too?

[@natez0690]

The gaskets are an o-ring type that seal each individual port and there are 8 of them on an LS. Not possible to use a gasket to port match an LS engine.

[@mikecastleberry9671]

Ok

[@mikecastleberry9671]

Watçh for thin spots with the Dremel

[@AlexGarcia-dj5gk]

How did you clean the inside ...if you cant reach the back did you dip in in something or rinsed with water or carb cleaner ?

[@KevinJonesYouTube]

I wash it with soap and water. Outside using a garden hose.

[@JoeHynes284]

@@KevinJonesKZbin awesome! literally what I did on my aluminum LT1 intake :)

[@DanielHamilton382]

@@KevinJonesKZbin Hey Mr. Jones do you have a recommendation for an epoxy? Is there a Derlin epoxy base that binds with derlin plastics like without amines or something like that some kind of nano tech?