Carved a Kitchen Conversion sign using the

Made this sign for my better half. I only used two bits. I used a 90 degree vbit for the words and 1/4 down cut endmill for the border and profile cuts. I painted the MDF first then sealed with shellac. Doing this helps the oramask stick to the wood and helps with a cleaner cut, enjoy!

[@ronnorris1504]

Wonderful piece! love using the oramask. Whenever i do a project for my wife and i use oramask, i make her weed it. LOL!

[@encarwoodworking]

Ron that’s a great idea! I may try to put my better half to work. If it doesn’t work out I’ll just say you suggested it lol

[@brandoncollins5694]

Looks great! I recently done a project using oramask and had a ton of little pieces I had to pick off. My wife had a cricut weeding tool and was way faster than the knife I was using. You should give one a try. Thanks for the video.

[@encarwoodworking]

Thanks for watching and the tip! It definitely is tedious picking out the oramask lol

[@kevinrich4637]

Nice job may I ask what your flat depth is?

[@encarwoodworking]

Looking back at the file it looks like if didn’t set a flat depth on the 90 degree vbit I used. Thanks for watching!