CGS Mod9 Tabletop review with modeling

[@bobborlog1677]

This is the level of nerding out on suppressors ive been looking for. Keep up the great work

[@44Mag]

I just got mine today. Man, that back plug is tight, and they do not include a tool to take it off so you can swap pistons or put a spacer in it. (Could not find one on their website either) - Basically had to get pliers after it. I think I read the Rugged tool fits it, so I will likely order one of those, or at least one of the third party made ones. Everything else looked good with it. Hopefully I will get to do a desk pop with it tomorrow.

[@silencerstudent9381]

@@44Mag should have been a little silver looking slug of metal

[@44Mag]

@@silencerstudent9381 Yes, it came with that tool, and it is used to take the front cap off. The tool does not work to remove the blast chamber. For that, you have to either use pliers, or buy a tool to fit it.

[@gocoach8707]

Are you supposed to align each cone with the cutouts in the same place? Mine throws all over the place? I shot it twice and my tube is completely carbon locked to the pistol housing. I can take the piston out but can’t unscrew the tube from housing. Do you have any recommendations?

[@silencerstudent9381]

ya but if u cant its not end of the world

[@bikenurse]

I can't wait to subscribe to patreon but I'm waiting until tomorrow so I don't get charged twice.

[@silencerstudent9381]

🎉 all you have to do is shoot me a message and i reverse it but welcome !

[@hksmith8581]

Do you have a link for that grease you use?

[@silencerstudent9381]

its called acculube, i source it from a friend usually

[@centerfiresuppressionllc682]

Foster from the old Form 1 discussion site.... Does anyone make tubes that fit the old DM caps? Thanks Bud, Sarge

[@silencerstudent9381]

i dont believe so but i dont stay up on that kinda stuff as well as i used to. more focused on research and stuff like that but nothing came to mind...

[@centerfiresuppressionllc682]

@@silencerstudent9381 Thanks

[@pswancey81]

Is the RSP rated for 9x39??

[@silencerstudent9381]

Let me ask to make sure but i see no reason why not

[@silencerstudent9381]

they said yes on subs but supers you need to be cautious not to get it over 600 degrees. (no full auto supers)

[@pswancey81]

@@silencerstudent9381 awesome!! Thank you very much.

[@wtfmrkratos]

Does anyone know if griffin makes an ez lok piston for the mod9?

[@silencerstudent9381]

no plus you would lose some performance as the piston is special. i have an entire series on testing their pistons on the members page. you can use the generic 1/2x28 thread adapter they make though for cam lok ez lok. watch the video on ways to attach suppressors to carbines as i go into that

[@ThompsonNydia-m8s]

Davis Robert Martin Richard Jackson Sandra

[@silencerstudent9381]

@@ThompsonNydia-m8s a lot of names

[@wwaldok]

My God. You sure can waste time.