Cheap eBay Roller Bender Unbox and Review

[@Avlec1000]

I was wondering about these tools, this video was super helpful!

[@juanbatistaa]

What gauge is the square tube?

[@mecano_s4486]

Hi. I have a question? Is there a rule or a formula to determine the coast of the distance between two lower rollers of a roller hanger (3 rollers). Thank you cordially

[@awesomecreationschannel]

Honestly I don't know. I haven't used it properly yet other than for testing purposes but if I do find out a formula for specific bends, I'll be sure to include it in the next video 😊👍

[@zico3239]

@@awesomecreationschannel i think your thickness sould be less than 2mm

[@vickykhandagale1807]

How much cost

[@Yosser70]

Do you thing you could do round tube in one of these? I’ve seen the sides of the rollers are adjustable, so wondering if you snugged them up to the pipe and went slow, it might work 🤷🏻‍♂️

[@awesomecreationschannel]

That's an interesting idea... I'll try it and let you know 😊👍

[@Yosser70]

@@awesomecreationschannel Noice one mate. Got my eye on that plasma cutter you reviewed a bit ago, any update on it?

[@awesomecreationschannel]

@@Yosser70 I've recorded an update but I just need to edit it. I was using this one to cut some 10mm steel plate and it was struggling to be honest. It didn't help that my workshop power supply couldn't handle the plasma cutter and the compressor running together 😑 I'm getting the power supply upgraded soon, but at the moment it's sort of unusable. It's not cutting properly but I don't know if I've messed something up.

[@Yosser70]

@@awesomecreationschannel Yeah power and a too small compressor wont help. Did you change the tip? Think you were running it too close before, needs to be 1 or 2mm off the surface I think. I’m no expert but been watching a load of videos about it recently.

[@awesomecreationschannel]

@@Yosser70 I had to buy new tips because the one that came with it burnt out. I don't use the compressor to much and I'm limited on space so I can't justify getting a bigger one yet. With this Andeli Cut 50, you have to touch to activate which causes a small amount of damage straight away. I think it's OK for thin stuff, but I've not tried it on anything since it started playing up 3/4 of the way round a sculpture I made out of the 10mm plate. I really need to get my editing sorted out 😅

[@darinkaintz386]

18:20