Chinese Diesel Heater - All the Fault Codes & How to Fix Them

[@CTM-Bikes]

i had another new heather laying here and changed this, now this one work fine but i cannot go into factory settings. normaly when you press setting key 3times you could enter the code but with me it will not work...cause?? thx

[@joneden7994]

Hi Just installing the heater...I've got error code F2 E06 come up. Not sure what the F2 means. I think the E06 is due to the casing catching with the fan. If I sort the E06 issue, will the F2 disappear? Thanks

[@EnglishHobbyMachinist]

@@joneden7994 I suppose the only way to find out is to fix the fan issue and see what happens

[@EnglishHobbyMachinist]

@@joneden7994 it can also be loose or damaged wiring

[@CTM-Bikes]

I dont get any code but my fan is going down an up in speed just afther a few hour of working, what could cause this?

[@EnglishHobbyMachinist]

@@CTM-Bikes sorry I don’t know, could be a faulty controller

[@mehdimoradi1041]

hello I changed the glow plug Battery with 12.8 voltage I even changed the main board The fuel line and pump are also healthy But it still gives error e03

[@EnglishHobbyMachinist]

@@mehdimoradi1041 most likely you positive cable is to small, try a heavier gauge cable

[@farahalali9635]

E12 What it mean

[@brianj9262]

Nope. Got error 02. Used a 110 volt to 12 volt dc power supply. Dropped 9.7 to 14.9. Still code 02

[@shlomogoldstein3373]

Mine does the same on cigarette lighter or 110 to 12v converter.

[@ellobo4195]

I get e-02 and e-08 . This unit is brand new, it worked good for 24 hours and now it won't work. I am using it to knock the chill off a garage so I can keep my plants warm. Very discouraging

[@EnglishHobbyMachinist]

@@ellobo4195 check your voltage and fuel

[@ellobo4195]

@@EnglishHobbyMachinist yes it was my car battery (brand new) down to 9volts. Hooked my battery charger to it and gave it a hour to charge, then left it hooked on running at 2 amps and the heater fired up. It pulls alot of amps. I guess I'm going to get a inverter for it.

[@EnglishHobbyMachinist]

@@ellobo4195 they pull about 20 amps at start up then run on virtually nothing.

[@jufalucian2762]

If there is air in the hose, how do I get it out?

[@EnglishHobbyMachinist]

@@jufalucian2762 remove the pipe to let the fuel through. If its a small amount it will work itself out eventually

[@jufalucian2762]

@@EnglishHobbyMachinist Thanks, The pipe between the tank and the pump or between the pump and the heater?

[@farahalali9635]

Please help me

[@EnglishHobbyMachinist]

@@farahalali9635 give me a clue

[@colemeyer7894]

I have two 5kw heaters. A few days ago I pressed the on button, the display came on, the fan kicked on and then the panel turned off and the machine never turned back on.

[@johnburns7512]

8 can also be too much carbon crap on burn chamber 🦘🇦🇺

[@EnglishHobbyMachinist]

@@johnburns7512 thank you