CITROEN/PEUGEOT FIX AC FAN NOT WORKING/RADIATOR FAN ALWAYS ON!

[@frv6610]

Very good video, thanks. When idling the car at night after a 400 km long drive the radiator fan started running at high speed for 10 min. It worked one time also during 5 min so why doesn't it keep working? How could it even start if the fan or resistor is bad? At night it was a little cold outdoors so I dont think the water temp sensor told the radiator fan to start or maybe it did? When you unplugged the water temp cable how was the radiator fan able to start when your resistor was broken? It's unlikely that both fan and resistor went bad? KingBole scanner says there is open or short circuit to both high and low speed of the radiator fan. C4 II (B7), 2013.

[@HOWTODO0828]

I installed a new fan resistor and that's why the fan start working back. The problem was with the fan resistor and not with the water temp sensor.

[@gerrykolaitis6515]

HI, great video. Hope you can help me for a similar issue. I have a 2014 Citroen DS3 1.6 L turbo petrol. When I turn the air con on, the compressor or the outside fan are not working and get warm air blowing through the vents. I have sacnned the ECU and get the following codes 0994 Aircon Compressor Clutch fault, 0997 Horn control fault, 040A Oil Gauge Fault and 05FF Unexpected re-initialisation fault coming from the BSI. I am not sure if they are all related or are separate faults. What can I test and check to identify the faults and fix? thank you.

[@HOWTODO0828]

Hi man, thank you for supporting me, first of all you have to fix the air compressor because it's not working due to clutch fail and it's not engaging, after that you have to check for freon leaks in the climatization sistem, after you get those to important parts fixed you can go ahead and see what other problems you have related to at not working. You have to take the car to a repair shop wich It's working with sistems of climatization, they will be able to do the checks with specialized tools 🙏

[@gerrykolaitis6515]

@HOWTODO0828 thank you. I have taken it to them and they couldn't really help me. They have said that it could be something else that's causing the compressor clutch fault and may not be a true code. Is there a way that I can manually trip the compressor to test it? They have confirmed it has gas. Also could the fan control module you replaced in this video be a fault that is stopping the compressor engaging or there is no relation between the fan working and the compressor turning on?

[@ashleysubbiah3866]

​@gerrykolaitis6515 have you found the fault with your car yet?

[@josef2748]

Hi, do you know if it's the same for the newer facelift model? Because I don't see the Resistor on the 'left' I only see a black Box on the Radiator mount, is it inside the box? Or a completely different circuit? Thank you!!!

[@HOWTODO0828]

Hello, yes it's în the black box. Open the box and you find it and then do the checks I showed you in the video 🙏good luck

[@dont.trust.anything]

How in the hell do you get the plastic cover of?? I have a 2011 1,6Vti c4, and I cant get it of? I need to losen the headlights to fight d the hidden bults, but thats not enough! 😢 do i need to get the hole bumper down?

[@HOWTODO0828]

You can take it down. It's not a big deal.

[@romeorametse]

Hello i replaced the same relay but my issue persist. I have a 207 and my car is stuck on low speed fan mode only AC in traffic doesn't blow cold air. Only blows cold air on a highway? Im curious with the under dashboard relay location. But im leaning more rowards replacing the fan inself

[@HOWTODO0828]

I recommend you to replace the resistor from under the dashboard. That resistor it's controlling the fan speed. Of the resistor it's bad only one speed it's working.

[@mohamadhanawi5767]

Great viedo thanks. I have 508 SW 1.6 diesel, the AC does not blow cold air. I googled and it might be becouse the fan is not working (one fan for the radiator and AC as here). I check and yeah the fan is not runing, can this be the issue? Which fuse is for the fan? do you know the exact location? Thanks in advance

[@HOWTODO0828]

Hello man, i don't know the exact location but you should check them like I showed in the video.Good luck and feel free to ask me anytime anything. 😎🙏

[@mohamadhanawi5767]

Thanks for the quick answer mate. I'll try to disconnect the temp sensor and check the fuse box as well. Keep the great work 💪 👏

[@mohamadhanawi5767]

​​@@HOWTODO0828 You are awesome mate. When I disconnected the water temp sensor the fan went on. Now to my question, my air-conditioning is now stopped blowing cold air, and the fan is not starting when I start the AC, can this resistor be the problem for no cold air?

[@mg4263]

I have a 207 with the same problem. AC just warm surrounding air. When I turn on the A/C Button lights up green but the fan does not run, and the compressor clutch doesn’t activate the compressor. A service had been done including refillment of R134a Gas but no change. I took out the relay and it was completely rusted green and not more working. I bought a new one oem PSA and when I installed it I will answer you guys. The repair shop wanted to sell me a new compressor 🙈 😂 I some cases a faulty Coolant Thermostat can also be the culprit for a not working A/C Compressor 😎

[@HOWTODO0828]

You could check the resistor and also the sensor from the smaller pipe from the AC. One pipe should be hot to touch and one very cold. The sensor should be located somewhere on the hot pipe (smaller one) also check the AC compressor and see if it's getting power.

[@OmarCespedes-y5k]

Gracias, me gusto como probaste el sensor saludos de Buenos Aires

[@HOWTODO0828]

You're welcome 💪

[@1984Assen]

Hi, my fans in the car are also not working same as the airco fan, you think this will also help both things?

[@HOWTODO0828]

Yes. This it's the first think you should replace before trying to replace the fans completely.

[@1984Assen]

@@HOWTODO0828 thnx Will try that

[@zekshajduk8854]

Great video. Thanks bro !!! 👍💪

[@HOWTODO0828]

My pleasure!🙏

[@dont.trust.anything]

How in the hell do you get the plastic cover of?? I have a 2011 1,6Vti c4, and I cant get it of? I need to losen the headlights to fight d the hidden bults, but thats not enough! 😢 do i need to get the hole bumper down? 😢

[@HOWTODO0828]

If you can't remove it like I did in this video just remove the entire front bumper off and you'll have more access to it.

[@dont.trust.anything]

@@HOWTODO0828 so much more time! Ill try and take it from under by just take the plastic shield of. But thx ! Do you know wich fuse to check? Inside and unde the Hood? The manual is not showing all fuses

[@HOWTODO0828]

I don't know sir

[@luisyepez9904]

Looks like I have the same problem. Thank you for the video.

[@HOWTODO0828]

Glad it helped🙏

[@wedkarskimiszmasz]

Does the Peugeot 806 HDI also have such a device?

[@HOWTODO0828]

Yes sir.

[@wedkarskimiszmasz]

@@HOWTODO0828 Thank you for your answer. I was looking for this item, but I can't find it. follow the cables from the fan, my cables go into the plastic tube and come out only in the relay box. The cables from the temperature sensor run all the way to the car's computer. Where can it be located?

[@antoniaydin]

I have a 207 from 2008 this one have the probleem that the fan always stays one. What could this be?

[@HOWTODO0828]

Try this method and it will help you.

[@vojtechpilar5809]

Great video! You don't need to do the hand thing like ChrisFix, it's rather funny.

[@HOWTODO0828]

Thanks you very much for your feedback, 😂yes Chris fix it's my mentor on KZbin and he s awesome 🙏

[@bog969]

Thanks for this video 👍👍👍

[@HOWTODO0828]

Glad I could help you. Don't forget to subscribe to my channel for more informative videos 🙏

[@80filipka]

I have the following problem. After turning on the engine (after a night in the garage, so the engine is cold), the fan starts spinning and continues to do so throughout the ride. Even after turning off the engine, it continues to spin for a few minutes. Can replacing this module help?

[@HOWTODO0828]

Yes, this can fix your problem but you also have to check if the coolant temperature sensor is working correct, if it's not working correct it sends signal to the fans that the coolant it's hot even if it's not and that's why the fans are kicking in, they start up to cool the engine because that's what the sensor it's teeling them to do. Check those two things and your problem should be fixed.

[@80filipka]

@@HOWTODO0828 I have already replaced the sensor you mention with a new one. so now I will replace this resistor and see if the fan stops spinning.

[@Warrax777]

Did it work ?

[@mperformancepack4792]

I've had this same fault before on another 1.2 and changed the fan resistor module which solved it. However on this car, the cooling fan is still not coming on. I've put direct power on to the fan which comes on. I've checked the loom connector and there's power there. The engine light has gone off, when I rescan the fault is still on ecu but won't clear. Coolant light came on so I stopped & the tank had coolant. When I opened it, it was like a jacuzzi 🤯. Any tips & help would be appreciated thanks.

[@HOWTODO0828]

If you cooland it's making bubbles when you open the cooland rezervor it's very possible that you have a problem with your water pump, or in the worse case you have a problem with your cilinder head gasket, also you could check with another fan from a junk yard and see if the can it's working or not, you could have a problem on your motherboard fan and that's why it's not starting when it should... Another thing you cand do it's to check all the fuses and see if you have something burned out. Hope it will help you 🙏

[@zoran.cvetkovic]

Great! Thank you!

[@HOWTODO0828]

You are welcome!🙏

[@JMMGF-c8t]

Merci beaucoup , vey clear

[@HOWTODO0828]

Your welcome 🙏

[@finimalik9744]

hello sir ,can u tell me how to fix temperature when hot temperature blow out at bottle coolant peugeot 3008

[@HOWTODO0828]

I don't understanding your question my friend, try to explain it a little more so I can understand and help you

[@finimalik9744]

@@HOWTODO0828sorry myfriend,maybe my english so bad ..ok,i explain more clear now..i have car peugeot 3008 now my car have problem system temperature,first i repair oil cooler and then flushing the radiator and i start the car until engine hot and i see temperature very fast so hot

[@finimalik9744]

@@HOWTODO0828 what is problem now temperature hot blow out bottle coolant peugeot 3008 ,how to do now myfriend ?

[@HOWTODO0828]

You need to bleed the coolant sistem, you have air in the system WICH need to be eliminated.

[@wendywhales2310]

Hi.. Should this component be called.....RESISTOR. Not Relay.. It does get confusing..

[@HOWTODO0828]

Yes, you're right my man 😎

[@TitaniumBMWGarage]

very thanks

[@HOWTODO0828]

Your welkome 🙏

[@mamamija15]

solve problem thanks

[@HOWTODO0828]

You're welcome 🙏don't forget to subscribe to my channel for more informative videos 😎

[@khaledwalid8894]

Very good but you speak fatser then eminem

[@HOWTODO0828]

😂Glad you liked it 😎

[@scorpionyad]

Не потрібно там знімати бампер.

[@HOWTODO0828]

Thank you for feedback

[@coskuncelik2908]

Farlari açinca hararet göstergesi 90 dereceden 95 dereceye yükseliyor..farları kapatinca 90 dereceye düşüyor fan rezistanı sağlam fan ve hararet müşürü saglam sorunu bulamadim

[@HOWTODO0828]

There are no problems, it's perfectly fine