Dude. You are a savior. I was stuck at the box under the steering wheel for an hour due to the center Clip. Every video said to tackle it from the front. Your side approach fixed it in 10 seconds. Mvp.
@user-fg2dr8qp5s11 ай бұрын
Legend I did take away that one tip about the centre clip on the sensor box. You're doing the Lord's work sir
@joshc4136 Жыл бұрын
Life saver! That middle clip on the box under the wheel had me stumped! I was able to use a small Allen wrench to get it.
@pinrod18 ай бұрын
Me too man, I felt like something was going to break, so I went searching
@rorieebert7 ай бұрын
Thank you so much for your very calm and logical description with steady video of how to remove the steering column module. It made this portion of changing the barrel much simpler.
@poloaguilar47443 ай бұрын
thank you for the video i just cant believe you took that off without removing the steering wheel
@sterlingsherrod190710 ай бұрын
Do it yourselfers' are GOD sent. Thanks chief. Yo VW - screw your corporation prices for simple 'hobby' labor work.
@acestevens43235 ай бұрын
Great vid mate Thanks
@annelodobasic6083 Жыл бұрын
Good job love your video!!!!
@SupervisorMartinez Жыл бұрын
Approximately how many wire did you unplug from the cylinder it self
@ckrummy13 Жыл бұрын
I believe it’s either 1 or 2. 1 is on the main body and the other is for the key reader but that might be a different part.
@SupervisorMartinez Жыл бұрын
@@ckrummy13 Update… Job Complete And Successful . Thanks For The Follow Through On The Procedure ….
@elflaco92105 ай бұрын
I fixed it, but now my horn doesn’t work anymore.
@ckrummy135 ай бұрын
Hmm not sure how that’s related. I would recheck your electrical connections. It would have to be something unhooked.
@elflaco92104 ай бұрын
@@ckrummy13mb yea I didn’t have it all properly connected 😔
@angelramirez-mc9jr10 ай бұрын
Does anyone know the part number?
@rillamagic7511 ай бұрын
What should I do if I replaced my ignition cylinder it worked at first but then now my key is not turning again
@ckrummy1311 ай бұрын
Make sure it’s not stuck on the steering lock. After that, maybe a warranty issue?
@DillionJones21 Жыл бұрын
What type of screw did you use from the micobit set you purchased from Walmart? Also can you please share the microbit set information? I’m attempting to remove the same screw & need to purchase a set with the screwdriver to remove it.
@ckrummy13 Жыл бұрын
Hyper Tough 44 Piece Precision Multi-type Screwdriver Bits Set TS99913A It’s a torques, not sure what size but that should be easy enough to figure out. Good luck
@bjthebrain968 Жыл бұрын
@@ckrummy13 just removed em on my BIL's 2010 Jetta earlier today. Were T25 for me.
@motodork Жыл бұрын
@@bjthebrain968that tiny one is not a T25. I really need to know what size it is.
@Yz4Life8 ай бұрын
@@motodorkI’m sure you’ve got it by now, but for anyone in the future - that very tiny bolt at the front of the steering sensor box is a T9
@enrestmoore35710 ай бұрын
Did this double-checked everything all my wires are connected everything is hooked up correctly replace the battery in my key I don't have the keyless entry I have a normal key just like in the video and when I start the car it dies it says no key detected
@ckrummy1310 ай бұрын
Any chance you damaged the receiver while you had it apart?
@enrestmoore35710 ай бұрын
@@ckrummy13 I'm not sure how to tell if I had
@ckrummy1310 ай бұрын
@@enrestmoore357 not sure if anything stands out to you, I would assume it’s a bad connection somewhere, there are a bunch of little ones. Have you tried it again a few hours later. I had an issue with the mobilizer 1 time, waited till the next day and it fired right up and hasn’t been an issue since
@TougeSolo Жыл бұрын
Sir your door thinks its a jar.
@EastDallasKicks9 ай бұрын
Mine failed at the gas station like 2 months ago very annoying