Just got my manual roll-sizer ... this truly address so many issues
@ReloadingMoreAD1966 Жыл бұрын
Nicely set 👍👍👌
@madmac450914 күн бұрын
How did that one case go through sideways?
@MolesNoMoreEurekaMO2 жыл бұрын
Nice! Can you share some specs on the motor and gearbox please? Make and model? Thanks!
@o2wow3 жыл бұрын
Does it have any effect on primer pockets?
@rollsizer56234 жыл бұрын
How are you finding the cases now after reloading? I love my rollsizers getting a thorough workout.
@christopher81874 жыл бұрын
I just ordered mine. How are you liking at after several months?
@rogueldr642smiythe93 жыл бұрын
Mine is sitting in Germany.
@firearmconvention9462 жыл бұрын
I assume I could rig my 550 spare casefeeder to a roll sizer? And who makes this roll sizer?
@firearmconvention9462 жыл бұрын
Nevermind i see it in the title
@wizzfred22 жыл бұрын
black guide is too high and you can fill the allen screew hole with 3D printed insert to avoid to case to fell off.
@MD823212 жыл бұрын
What is the correct spacing from the drop tube to the rollsizer die?
@wizzfred22 жыл бұрын
@@MD82321 based on my experience, distance between bottom plate and drop tube have to be =(lenght of case + 2mm). if proble occurs again, you can reduce it
@MD823212 жыл бұрын
@@wizzfred2 Thanks. I guess if all else fails, read the instructions!
@wizzfred22 жыл бұрын
@@MD82321 give me your feedback
@sortac083 жыл бұрын
What's the purpose of the roll sizer?
@rollsizer56233 жыл бұрын
brett, the rollsizer removes the bulge at the base where the fulle length sizing die cannot reach, it brings the base back to a factory size, gets the case Concentric (can't do that with sizing dies) and squares the base of the case up with the rim. they are not obvious but they make a huge difference to reliability. You get factory grade ammunition with reloads even after 40-50+ reloads.
@randylahey22425 ай бұрын
@@rollsizer5623 lol no one is reloading the same 9mm case 50 times. And even if you could the rim would still degrade and not be near as reliable as factory
@rollsizer56235 ай бұрын
@@randylahey2242 around 40 reloads ( mine), the 38sc cases were getting thin sidewalls and starting to crack. I shot the Nationals (3rd open senior) and a state title (1stbopen senior) with them. They were scrapped around the 45 mark.
@Esper3204 ай бұрын
@randylahey2242 you don't reload at all, so why are you even typing
@randylahey22424 ай бұрын
@Esper320 you don't reload, be gone brokie
@chgofirefighter2 жыл бұрын
So slow! for that get the manual operated one, install a cordless drill/or powered to the crank and it'll operate run faster process brass a bit more faster~