Craftsman 137.248760 Table Saw RM871 Motor Rebuild

Can it be fixed? Craftsman 137.248760 Table Saw RM871 Motor Rebuild

[@BasicPoke]

Sure would have been cool if you had showed how to rebuild the motor. But thanks for a little info anyway.

[@robertsykes7831]

Any chance you know where we can get a new armature, or even just the armature fan? I have managed to repair the rest of mine, except that...

[@radar98]

there are motor rebuild kits from Amazon and sears

[@stevevoelkel78]

Can you link where you got the kit please?

[@radar98]

Follow this link and there should be all of the parts listed on the same Amazon page www.amazon.com/dp/B089FSKWFH/ref=cm_sw_r_cp_apa_i_9JjaGbCBS4WD3

[@rickpenrod1734]

WOW you didn't show anything really, other than before and after

[@radar98]

Sorry. It was rushed. But it's pretty basic to disassemble it. You'll need about an hour if you have all of the tools.

[@Masticas.]

😂

[@sidbergman1068]

What size gear puller?

[@radar98]

The bearing was more than two inches across, so anything bigger really. My first attempt was with one that was just too small.

[@rexdiane]

Where did you buy your new parts. I need the rubber stop for the bearing because mine got hot.

[@radar98]

Too expensive, but here's a link. I would just use epoxy if I could, but here ya go. www.amazon.com/dp/B089FSKWFH/ref=cm_sw_r_cp_apa_i_9JjaGbCBS4WD3

[@mcm740]

Didn't show if it came off easy with puller

[@radar98]

Oh, yeah. It does, as long as it is the correct size puller.

[@Zepher20T]

How the fuck do you put it back in tho thank you for completely skipping that part.

[@radar98]

Which part?

[@jepper80]

?

[@refugiollamas7350]

Waste of time.