BMW E60/E90 Transfer Case Servomotor Actuator Shaft Part 2

[@pastorghawk]

Thanks ... I just replaced the entire servomotor. It didn’t go as smooth as yours but I got it in ... Thanks...

[@skymaracle]

Hi George, I'm pretty sure I have the same issue, checked my codes too seems to be legit, my question is did you have any noise upon starting the car?

[@martindimitrov1955]

А какво мислиш за китайските моторчета? Механиката им е същата, не знам електрониката как се справя

[@jimmybrendmo8376]

Hi. Had the alarms: 4x4 system and DSC, 4x4 system Faulty. Replaced the shaft (easy job thanks to your movie), the shaft was quite worn. After driving a few meters alarms : 4x4 system faulty and DTC active comes, goes in and out. Car run 36x xxx km, ecotune software (300 electronic hp...). Never had any issues before. Any solutions on my problem? Thank you.

[@GHK330]

Здравей, after you change the servomotor, do you have to initialize the new one? Thanks

[@thevigilagency]

Was it making a slight grinding noise when it failed?

[@joeblack1698]

Did the code go off by itself

[@doblin3]

Can yoiu help me out. I had my motor actuator replaced but my lights are still on. What should I do?

[@crank3646]

Is it replaced with new one or second hand unit ? If the unit is OK , and the wiring to the unit is checked , there should be some damage inside the transfer case then .

[@pastorghawk]

I just replaced one and the light stayed on... I then turned the wheel all the way right then left and the light went off...